Best sellers

DEV-10867 - Conductive Thread Bobbin - 30ft (Stainless Steel)

A set of 10 M2.5 screws with a length of 6mm with Philips head

ROB-09454 - QRE1113 Line Sensor Breakout - Digital

Camera module with Sony Starvis IMX290 sensor that works with Raspberry Pi minicomputers. It has a 2 MP sensor and an 80° viewing angle lens, and is equipped with a movable IR-CUT filter. ArduCAM B0424

The Step-Up Buck Voltage Regulator module with output voltage of 3.3V and input voltage range of 1-3V and a maximum output current of 200 mA. SparkFun PRT-10967

AR0234 sensor module that works with NVIDIA Jetson Nano and Xavier NX kits. The sensor used has a 2.3 MP sensor and allows video recording at 1920×1200@30fps. It is equipped with a global shutter. ArduCAM B0429

An adapter for signal analysis during data transfer to a microSD card. The adapter allows you to connect a signal analyzer or other device in parallel to the system working with a microSD card. SparkFun TOL-09419

The module is based on the Si4703 FM tuner system. Supports wave reception in a wide frequency range from 76 to 108 MHz. It allows you to read RDS information. SparkFun BOB-11083

A set of 20 M2.5 screws with a length of 6mm with Philips head

A set of 20 M3 screws with a length of 10mm with Philips head

A set of 100 M2.5 screws with a length of 6mm with Philips head

A set of 10 M2.5 screws with a length of 8mm with Philips head

A set of 100 M2.5 screws with a length of 8mm with Philips head

A set of 10 M2.5 screws with a length of 10mm with Philips head

A set of 20 M2.5 screws with a length of 10mm with Philips head

A set of 100 M2.5 screws with a length of 10mm with Philips head

2.4 GHz RF module with nRF24L01+ chip. The module has an RP-SMA connector with reverse polarity, allowing the connection of an external antenna. The system has a built-in 3.3 V stabilizer and IO lines with a tolerance of 5 V. SparkFun WRL-00705

90° angled antenna cable, 1.5 m, with double shielding and IEC-type connectors, provides reliable connections in TV and radio installations. The angled connectors facilitate installation in hard-to-reach places, while effective shielding minimizes interference, ensuring high signal quality.

Nozzle designed for 3D printers with a Volcano hotend. It is much longer than standard V6 nozzles, which makes it possible to achieve higher print speeds. The Teflon coating prevents the filament from sticking to the nozzle

Female terminal block, angled, 10-pin. Pitch 5.0mm. Height 15mm. 2EDGK-5.0-10P