Best sellers
There are 16481 products.
The cable (adapter) of the USB type A connector to the "alligator" type connector. It allows you to conveniently connect the USB power supply to the pads on the board or pins of another connector
Module of a stereo 24-bit audio converter with I2S interface (TS4657).
ST7 MCU, 4kB Flash, 384B RAM, 128B EEPROM, LQFP32, RoHS
Adapter from SOP28 to DIP28 in the form of a PCB. It will be used as a programmer adapter, contact plates or prototype structures.
LSF0204PWR, 4-Bit Bidirectional Multi-Voltage Level Translator for Open-Drain & Push- Pull, TSSOP14
The board with the RP2040 microcontroller equipped with two ARM Cortex-M0 + cores operating at a frequency of 133 MHz, 264 kB RAM. There is as much as 16 MB of QSPI flash memory on the board. The system can be programmed in C / C ++ or microPython. Soldered connectors. KApico RP2040
5 mm Red Diffused LED, 45 degree angle; light intensity 500 mcd (20mA) (type.2V); df 625nm
2-wire installation coupler, 450 V, 4 kV, 32 A, with levers. Wago 221-2411
Silicone cover for the heating block of a Volcano type 3D printer. Provides an increase in nozzle temperature stability, especially when cooling by air flow
The module allows you to send UART (TTL) bus signals to a computer via a USB port. The adapter operates based on the PL2303HX chip and is recognized in the computer as a virtual serial port
Large heat sink in the form of a case covering the entire board with double fan. Designed for Raspberry Pi 4 minicomputers.
A flexible cable type AA (tape) with a length of 20 cm. The tape has 20 wires and a pitch of 0,5 mm
KAmodRPi Pico Quad Expander enables simultaneous connection of multiple extensions to Raspberry Pi Pico, providing convenient signal distribution and I2C bus support. The module is intended for projects requiring an extended connection topology and integration of numerous peripherals.
8-Bit Dual-Supply Bus Transceiver with Configurable Voltage Translation and Three-State Outputs, TSSOP24, TI
Silicone cover for the heating block of a V6 type 3D printer. Provides an increase in nozzle temperature stability, especially when cooling by air flow
ARK terminal connector with a fuse, 5-pin, pitch 10.00 mm, non-detachable
2p male plug angled for PCBs, 2.54mm thick, tinned, white color. Set of 10 pieces
Flex Cable for Raspberry Pi Camera - 300mm / 12"
