Waveshare PL2303 USB UART Board (type A)

UART-RS232 converter module. It enables communication of Arduino boards with industrial modules. DFRobot DFR0258

A small USB-UART TTL converter module based on the CH340 system with a USB type A connector. Designed for the ESP-01 and ESP-01S modules

ZL5USB is a USB-UART converter module based on Silabs CP2102. The module has small sizes, microUSB connector and it can works with the 2.5...5.5V signals.

USB - UART converter based on the CH9102F chip. Compatible with the voltage of 3.3 V and 5 V, it has been equipped with a USB type C connector. Adafruit 5568

USB - RS485/RS422/RS232 converter designed to convert USB signal to serial signal. It is used to connect devices with USB interface to RS485, RS422 or RS232 network. It uses ADI (Analog Devices iCoupler) galvanic isolation technology. EVC8013B

USB - UART converter based on the PL2303 chip

This is a basic breakout board for the FTDI FT232RL USB to serial IC. The pinout of this board matches the FTDI cable to work with official Arduino and cloned 5V Arduino boards. It can also be used for general serial applications. DEV-09716

Overlay module for Raspberry Pi with GSM, GPRS, GNSS and Bluetooth

The cable is easiest way ever to connect to your microcontroller/Raspberry Pi/WiFi router serial console port. The power pin provides the 5V @ 500mA direct from the USB port and the RX/TX pins are 3.3V level for interfacing with the most common 3.3V logic level chipsets. Adafruit 954

The FT232RNL USB to UART converter provides stable serial communication and debugging of industrial equipment, supporting 3.3V and 5V voltages and hardware flow control. With power indicators, protection diodes, and compatibility with multiple operating systems, it offers reliable data transfers from 300 bps to 3 Mbps, as well as additional protections against faults and electrostatic discharge. Waveshare USB TO TTL (C)

USBRS232 interface with galvanic isolation

USB-UART converter with four isolated UART ports with built-in isolation of 1.5kV/3kV. It guarantees data transmission speeds of up to 12 Mbps and the ability to work with 1.8 V or 3.3 V voltage systems on the UART side. It is equipped with a USB Type C connector and is capable of operating in a wide temperature range from -40°C to +55°C. Electronic Prototypes EPED001A-10-STD

UART-RS232 converter module. The board was equipped with a Grove and DB9 connector. Seeed Studio 103020192

The UART-USB converter built on the FTDI FT232RL chip. Compatible with 3.3V and 5V voltages. DFRobot DFR0065

UART - USB converter based on the FT232RL chip with TX, RX, RTS and CTS lines led out to the pin connector, the remaining lines available on solder fields for pin connectors. Micro-USB socket. Voltage supply from 3.3 to 5 V. FT232 USB UART Board (micro)

USB - RS-232 USB A (m) / D-Sub (m) cable with a length of 1 m. Akyga AK-CO-02