The CP2102 USB UART Board (type A) is an accessory board that features the single-chip USB to UART bridge CP2102 onboard.
CP2102 features:
In the case of working with a MCU:
Note: VCP examples and USBXpress driver program library are provided.
Wiki : www.waveshare.com/wiki/CP2102_USB_UART_Board_(type_A)
Manufacturer
Responsible person
CP2102 USB to UART Module, USB micro connector
The UART-USB converter built on the FTDI FT232RL chip. Compatible with 3.3V and 5V voltages. DFRobot DFR0065
WIFI-LPT100 Eval Kit module enables UART data transmission via WiFi, ultra low power consumption, encrypted communication
No product available!
USB - UART converter based on the PL2303 chip
UART - RS232 converter with DB9 socket. Waveshare rs232-board
Overlay module for Raspberry Pi with GSM, GPRS, GNSS and Bluetooth
Xbee USB adapter based on the FTDI chip. Intended for configuring Xbee modules. Thanks to the female goldpin connector, it can be used as an FTDI programmer for Arduino FIO / pro / mini / lilypad. DFRobot DFR0050
The UART-USB converter built on the FTDI FT232RL chip. Compatible with 3.3V and 5V voltages. DFRobot DFR0065
USB - UART converter based on the FT232RL chip. Compatible with voltages of 3.3 V and 5 V, it is equipped with a microUSB connector. Cytron UC00A
No product available!
USB - UART TTL converter based on the FT232RL chip, the module is equipped with a miniUSB socket. Works with 3.3V or 5V voltage levels.
USB port isolator based on the ADUM3160 chip. The device has a rated insulation voltage of 1500V. The isolator is powered from the USB port.
A small USB-UART TTL converter module based on the CH340 system with a USB type A connector. Designed for the ESP-01 and ESP-01S modules
UART-RS232 converter module. The board was equipped with a Grove and DB9 connector. Seeed Studio 103020192
USB adapter designed for XBee modules. It can be connected to a computer with a USB cable and used with the X-CTU software to configure the XBee. DFRobot DFR0174
RS232 - UART converter module based on the MAX3232 chip. There is a DB9 connector on the board and a 4-pin connector with a 2.54 mm pitch
USB - RS-232 USB A (m) / D-Sub (m) cable with a length of 1 m. Akyga AK-CO-02
The module with the UART-RS232 converter is designed to work with the Raspberry Pi Pico. It has a built-in SP3232EEN chip and enables data transmission between the UART interface and the RS232 device. Waveshare Pico-2CH-RS232