DigiLab for Flipper Zero - Diagnostic Module for Digital Electronics Analysis

Description

Diagnostic module for Flipper Zero (not included) allows electrical signals to be analyzed without building an additional measurement system based on a microcontroller. The Scope function displays the signal waveform in real time and shows instantaneous, average and maximum voltage. Information about the measured signal can also be indicated using the Flipper Zero speaker, vibration motor and RGB LED, making it easier to distinguish voltage changes, bus activity and other signals while working with a circuit.

The Probe function is designed for rapid identification of signal lines during electronics development and debugging. It measures voltage from 0 V to 12 V and signal frequency up to approximately 200 kHz, allowing users to check power rails, active communication lines, clock signals and serial transmission. The interface displays voltage and frequency in real time, helping locate relevant test points on a PCB.

The I2C Probe and SPI Probe modes allow devices connected to I2C and SPI buses to be detected and identified. The built-in identification engine can recognize devices based on available information and display details such as device type, address, reference, manufacturer and description. Available tools include a register explorer, register editor with read and write support, and a hexadecimal data editor.

DigiLab also allows direct reading and writing of data in sensors, memory devices and other peripherals communicating over I2C and SPI. The GPIO pinout is compatible with Bus Pirate accessories, allowing compatible cables and probes to be used. The hardware and software are Open Source and Open Hardware, making the module suitable for diagnostics, prototyping, learning digital buses and signal analysis.

Features

• Measurements and signal analysis
  
  • Compatible with Flipper Zero
  • Scope function for waveform observation
  • Instantaneous, average and maximum voltage measurement
  • Voltage measurement range: 0 V to 12 V
  • Frequency measurement: up to approximately 200 kHz
  • Real-time voltage and frequency display
  • Feedback using sound, vibration and RGB LED
  • Alert functions for selected voltage and signal conditions
• I2C and SPI support
  
  • I2C device detection
  • SPI device detection
  • Identification of connected devices
  • Support for multiple devices on a bus
  • Display of device type, address, reference, manufacturer and description
  • Register explorer
  • Register read and write
  • Hexadecimal data editor
  • Direct communication with sensors, memory devices and other peripherals
• Design and compatibility
  
  • GPIO pinout compatible with Bus Pirate accessories
  • Open Source
  • Open Hardware
  • Support through the dedicated DigiLab application for Flipper Zero

Kit includes

• 1 x DigiLab module
• 1 x probe pair with shielded RG-178 cable and SMA connector
• 1 x screw-mounted probe point