Grove Green Wrapper 1*1 - mounting for Grove modules (green) - 4 pcs.

Module with light sensor - LS06-S phototransistor. The board is equipped with a Grove connector and has an analog output. Seeed Studio 101020173

Grove starter kit dedicated to Raspberry Pi minicomputers. Contains basic sensors and modules necessary for learning programming and electronics. Seeed Studio 110020169

Module with a black and white OLED display with a diagonal of 1.12" and a resolution of 128x128 px. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020452

Module with a MLX90640 thermal imaging camera with a 32x24 field matrix and a 110° viewing angle. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 114020142

Module with FM receiver, with its help it is possible to receive radio waves broadcast in the FM band (frequency 50-115MHz). The module has been equipped with a 3,5mm jack socket, through which you can connect headphones. The module has a connector in accordance with the Grove standard. Seeed Studio 107020006

Waterproof strip with RGB LED diodes, 1 m long (60 LEDs per meter). The LEDs are mounted on a flexible white PCB, the tape has a Grove connector. Seeed Studio 104020109

Module with RGB diode and P9813 controller. It is powered with the voltage of 5 V and controlled by the I2C interface (Grove). Seeed Studio 104030006

A volume sensor designed to detect loud ambient sounds. The module uses a microphone and LM2904 amplifier. The output value (analog signal) depends on the volume of the detected sound. In order to eliminate interference, the microphone signal is subjected to double filtering. Seeed studio 101020063

Module with 2-element 14-segment display with red backlight. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 104020132

Starter kit with nRF52840-MDK evaluation board and Grove modules designed for the development of Mesh networks. Seeed Studio 110061007

Set (5 pieces) of wires for attaching modeling servos with the Grove system. With one wire you can connect 2 servos to one Grove slot. Seeed studio 110990057

Module with two DRV8830 DC motor drivers. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 105020010

Starter kit with Grove modules, which allows you to see the possibilities of the Azure platform. Seeed Studio 110060742

A 4-core cable with a length of 50 cm, both terminated with a Grove plug. Seeed Studio 110990038

Base Shield V2 is an extension for tiles with an Arduino shield connector, it has a Grove connector, which can be connected to Grove-compatible modules / sensors. Seeedstudio 103030000

Module with a TDS sensor that allows you to measure the total content of solids dissolved in water. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020753