915MHz wireless transceiver module
ID: 573531
zł23.28
Tax included
zł18.93 tax excl.
Wireless transceiver operating in the 915MHz band based on the RFM69HCW chip with a maximum power of 100mW and a transmission speed of up to 300kbps. The range in open space is up to 500m. The module communicates via the SPI bus. Arduino compatible. modRFM69HCW_915MHz
Description
Wireless transceiver operating in the 915 MHz band based on the RFM69HCW chip. Works on frequencies in the ISM band. The maximum power is 100 mW and the transmission speed is up to 300 kbps. The range in open space is up to 500 meters. The module communicates via the SPI bus. Arduino compatible.
Features
- +20 dBm, 100mW Power Output Capability
- High Sensitivity: down to -120 dBm at 1.2 kbps
- High Selectivity: 16-tap FIR Channel Filter
- Low current: Rx = 16 mA, 100nA register retention
- Programmable Pout: -18 to +20 dBm in 1dB steps
- Constant RF performance over voltage range of chip
- FSK Bit rates up to 300 kb/s
- Fully integrated synthesizer with a resolution of 61 Hz
- FSK, GFSK, MSK, GMSK and OOK modulations
- Built-in Bit Synchronizer performing Clock Recovery
- 115 dB+ Dynamic Range RSSI
- Automatic RF Sense with ultra-fast AFC
- Packet engine with CRC-16, AES-128, 66-byte FIFO
- Embedded temperature sensor
573531
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
Module with ATmega32u4 microcontroller and 900 MHz wireless transceiver. The module can be used for transmission in the ISM 868 MHz band after the appropriate software configuration. The microcontroller is clocked at 8 MHz and works at 3.3 V. Adafruit 3076
zł147.12
Delivery date unknown
No product available!
A wireless transceiver operating in the 434 MHz band based on the RFM69HCW system. Maximum power: 100mW; bit rate up to 300kbps. Range in the open space reaches up to 500m. The module communicates using the SPI bus. Compatible with Arduino
zł14.24
24h
Available quantity: 6
Available
Development board with a 32-bit ATSAMD21G18 microcontroller based on Cortex-M0 core. The module also has an RFM69HCW chip that allows wireless communication in the 433 MHz band. Adafruit 3177
zł147.12
Delivery date unknown
No product available!
Module with ATSAMD21G18 microcontroller and 900 MHz wireless transceiver. The module can be used for transmission in the ISM 868 MHz band after the appropriate software configuration. The ATSAMD21G18 microcontroller (ARM Cortex-M0) is clocked at 48 MHz and operates at 3.3 V. Adafruit 3176
zł147.12
24h
Available quantity: 1
Available
Other products in the same category (16)
A set with a radio transmitter and receiver operating at 315 MHz. The modules are equipped with Grove connectors and communicate via a digital interface. Seeed Studio 113020001
zł50.26
24h
Available quantity: 2
Available
Radio transmitter module operating at 433 MHz. It is equipped with Gravity connectors and communicates via a digital interface. DFRobot TEL0140
zł30.55
24h
Available quantity: 3
Available
Expansion board for STM32 Nucleo based on S2-LP RF transmitter operating in 868MHz band. The expansion board is compatible with ST morpho and Arduino UNO R3 connectors. STMicroelectronics X-NUCLEO-S2868A2
zł161.81
24h
Available quantity: 2
Available
The FS1000A transmitter and the MX-RM-5V receiver enable communication in the ISM band; they are easy to use, do not require advanced bus control and have very small dimensions. Especially recommended for work with Arduino and STM32
zł5.63
24h
Available quantity: 22
Available
Available
Available
Radio module with the RFM69HCW (868 MHz or 915 MHz) system, designed to work with the Raspberry Pi. Equipped with an OLED display and buttons. Adafruit 4072
zł110.65
24h
Available quantity: 1
Available
Module with nRF24L01 + transceiver, power amplifier and antenna with 2dBi gain, 1000m, 2Mb / s, RoHS
zł12.88
4 weeks
No product available!
HAT module with RFM95W 868 MHz system for LoRa/LoRaWAN communication and OLED display, designed for Raspberry Pi minicomputers. Adafruit 4074
zł197.59
24h
Available quantity: 1
Available
WIFI-LPT100 Eval Kit module enables UART data transmission via WiFi, ultra low power consumption, encrypted communication
zł110.76
4 weeks
No product available!
Module with a 433 MHz radio receiver for M5Stack sets. Based on the SYN531R chip, it has a built-in PCB antenna. M5Stack U113
zł24.53
24h
Available quantity: 3
Available
ModCC2540-A1 allows the use of Bluetooth transmission features BLE 4.0 - thanks to the built-in CC2540 chip, it is possible to create complex projects without the use of an additional microcontroller. modCC2540-A1
zł30.80
24h
Available quantity: 4
Available
Wireless communication module based on the NRF24L01 chip. It is designed for SMD mounting and will be perfect for the construction of small devices
zł6.43
4 weeks
No product available!
NRF24L01 module with UART serial interface. It has a built-in antenna and a microcontroller that acts as a converter. It allows the design and testing of 2.4 GHz radio communication via a serial interface
zł35.18
24h
Available quantity: 3
Available
A wireless transceiver operating in the 434 MHz band based on the RFM69HCW system. Maximum power: 100mW; bit rate up to 300kbps. Range in the open space reaches up to 500m. The module communicates using the SPI bus. Compatible with Arduino
zł14.24
24h
Available quantity: 6
Available
Module with a radio receiver operating at 315 MHz for Arduino. DFRobot TEL0075
zł33.73
24h
Available quantity: 1
Available
Wireless transceiver operating in the 915MHz band based on the RFM69HCW chip with a maximum power of 100mW and a transmission speed of up to 300kbps. The range in open space is up to 500m. The module communicates via the SPI bus. Arduino compatible. modRFM69HCW_915MHz