

A set of 10 cables, 30 cm long, for analog sensors compatible with the Gravity standard. The cable is terminated on one side with a JST PH2.0-3P connector and on the other with a goldpin 2.54 mm connector. It allows to connect the Gravity modules to the control board, eg Ardunio.
Data sheet
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Arduino Uno Rev3 is a popular board with Atmel ATmega328 microcontroller from the AVR family, there are 14 I / O lines, 6 PWM channels and 6 analog inputs. The additional ATmega16U4 microcontroller realizes communication via the USB interface. Arduino A000066
Expansion board for Arduino, allows easy connection of XBee modules, has separate outputs for I2C, SPI and UART buses. The built-in 3.3V voltage stabilizer and operating mode switch make it easier to program the Arduino when the XBee module is connected to the sockets. DFRobot DFR0265
A set of 10 cables, 30 cm long, compliant with the Gravity standard. DFRobot FIT0513
4-wire cable with a length of 100 mm. Both ends with STEMMA QT (Qwiic) plug. Adafruit 4210
Qwiic to Grove adapter cable, 100 mm long. Enables interoperability between the SparkFun Qwiic Connect system and Seeed Studio I2C-based Grove boards. SparkFun PRT-15109
No product available!
11-wire cable, 100 mm long, with a JST SH-1.0 female plug at both ends
4-pin cable with JST SH connector compatible with STEMMA QT/Qwiic, terminated with spring probes. Adafruit 5037
8-wire cable, 10 cm long, with a JST SH-1.0 female plug at one end
2-core cable, 20 cm long, with JST PH plug (2mm pitch). The ends of the wires are isolated and tinned
4-core cable with a length of 300 mm. Both ends with STEMMA QT (Qwiic) plug. Adafruit 5384
11-wire cable, 10 cm long, with a JST SH-1.0 female plug at one end
2-wire cable, 10 cm long, with a JST SH-1.0 female plug at both ends
A 20 cm long 3-pin cable with a JST XH2.5 female plug on one side
7-wire cable, 10 cm long, with a JST SH-1.0 female plug at both ends
A 20 cm long 6-pin cable with a JST XH2.5 female plug on one side
The cable is terminated on one side with a female connector JST RCY (BEC)
4-pin cable with JST SH connector compliant with STEMMA QT/Qwiic. Ended with alligator clips. Adafruit 4398
A 20 cm long 5-pin cable with a JST XH2.5 female plug on one side
11-wire cable, 10 cm long, with a JST SH-1.0 female plug at both ends
Set of 10 cables, 30 cm long, for analog sensors compatible with the Gravity standard. DFRobot FIT0031