- Out-of-Stock

Dual driver for DC motors. It allows you to control two drives with a voltage in the range from 4.5 to 13.5 V. The controller is based on the Toshiba TB6612FNG chip, thanks to which a current of 1 A (3 A temporary) can be taken from each channel. The module allows you to connect a microcontroller or a computer with a serial port (an external RS-232 level converter is required) or a USB-UART adapter. The protocol used uses the function of automatic detection of baud rates up to 38.4 kbps and optional CRC error control. Two status LEDs provide visual feedback on the serial connection and any errors for easy debugging, while the demo mode allows you to easily verify correct operation. The controller uses a high-frequency PWM (ultrasonic) signal to eliminate the switching-induced motor hum.
Data sheet
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
TB6612FNG Dual Motor Driver Carrier
USB - UART converter based on the FT232RL chip. Compatible with voltages of 3.3 V and 5 V, has been equipped with a USB type C connector. Waveshare FT232 USB UART Board (Type C)
USB - UART converter based on the PL2303 chip. Compatible with voltages of 1.8 V, 2.5 V, 3.3 V and 5 V, it is equipped with a USB type A connector. Waveshare PL2303 USB UART Board (type A) V2
No product available!
No product available!
Camera with a resolution of 8 MPx with a USB interface. Equipped with a CMOS IMS179 sensor with a wide-angle lens with a viewing angle of 150°. ArduCAM UB0233
No product available!
No product available!
AC/DC power adapter with a power of 180 W and an output voltage of 19.5 V. It is equipped with an output with an XT60 plug and is designed for universal chargers with an XT60 connector, e.g. ToolkitRC M6. ToolkitRC ADP180
No product available!
SanDisk Extreme microSDHC memory card with a capacity of 32GB, maximum reading speed up to 100 MB / s, U3 UHD class
No product available!
No product available!
No product available!
This high discharge LiPo - a great way to power any R/C, robotic, or portable project; excellent choice for anything that requires a small battery with a lot of punch. This battery has two cells and outputs 7.4V storing 2200mAh of charge. PRT-11856
No product available!
No product available!
No product available!
Kit with Raspberry Pi Zero 2 WH with soldered connector, official accessories and Waveshare USB hub
No product available!
No product available!
No product available!
ZL2MCS51 - development kit for MCS51 microcontrollers (AT89C51RD2)
No product available!
Arduino. 36 projects for electronics enthusiasts; Simon Monk
No product available!
A double motor driver that allows you to drive two DC motors with a voltage from 4.5 to 13.5V and a continuous current of 1 A per channel. It communicates via the serial interface. Pololu 1110