- Out-of-Stock

Dual driver for DC motors. It allows you to control two drives with a voltage in the range from 4.5 to 13.5 V. The controller is based on the Toshiba TB6612FNG chip, thanks to which a current of 1 A (3 A temporary) can be taken from each channel. The module allows you to connect a microcontroller or a computer with a serial port (an external RS-232 level converter is required) or a USB-UART adapter. The protocol used uses the function of automatic detection of baud rates up to 38.4 kbps and optional CRC error control. Two status LEDs provide visual feedback on the serial connection and any errors for easy debugging, while the demo mode allows you to easily verify correct operation. The controller uses a high-frequency PWM (ultrasonic) signal to eliminate the switching-induced motor hum.
Data sheet
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
TB6612FNG Dual Motor Driver Carrier
USB - UART converter based on the FT232RL chip. Compatible with voltages of 3.3 V and 5 V, has been equipped with a USB type C connector. Waveshare FT232 USB UART Board (Type C)
USB - UART converter based on the PL2303 chip. Compatible with voltages of 1.8 V, 2.5 V, 3.3 V and 5 V, it is equipped with a USB type A connector. Waveshare PL2303 USB UART Board (type A) V2
No product available!
Assembled remote two-channel switch PILOT. AVT5455 / 1 C
No product available!
The module of the SD and MMC memory card reader ("large") with the card lines led out to the 2.54 mm connector mounting area /. It allows easy connection of the SD card to the project being built. BOB-12941
No product available!
No product available!
No product available!
Black microHDMI-HDMI cable with a length of 1 meter. Compliant with HDMI v1.4 specification. Lanberg CA-HDMI-12CC-0010-BK
No product available!
A small mobile battery with a capacity of 4000 mAh for charging portable electronic devices, powered by 5V. The power bank is charged via the USB port . The level of charge is indicated by means of LEDs. PB11 4000 mAh pink
No product available!
No product available!
No product available!
Grapic LCD 128x64, 75x52.8mm, STN NEGATIVE BLUE, LED backlight white, enhanced temperature range; KS0108 compatible controller
No product available!
Board with ATmega32U4 and Atheros AR9331. It combines the advantages of a microcontroller and a microprocessor with Linux. The set has 32 KB flash memory, 20 digital inputs / outputs, including the ability to configure 7 as PWM channels and 12 as analog inputs (ATmega32U4) as well as a WiFi module and a microSD card slot (Atheros AR9331). Arduino Yún Rev2
No product available!
No product available!
No product available!
No product available!
No product available!
Kinetis L Series Cortex-M0+, 32bit MCU, 256 KB Flash , QFN32, Freescale, RoHS
No product available!
A double motor driver that allows you to drive two DC motors with a voltage from 4.5 to 13.5V and a continuous current of 1 A per channel. It communicates via the serial interface. Pololu 1110