

PmodAMP3
Stereo Power Amplifier, Digilent, RoHS
The Digilent PmodAMP3 features an Analog Devices SSM2518 2 watt Class-D Audio Power Amplifier. The module enables the use of I2S audio protocol or TDM to produce stereo audio at various sampling frequencies. The module features configurable digital volume and dynamic range control via an I2C interface. Additionally, you may use the AMP3 in a stand-alone mode that does not require the use of the I2C interface.
Key Features:
Contents:
Code: 210-270
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
No product available!
Module with an AB class amplifier based on the Boomer® LM4853 system. It can work in two modes: mono (power 1.5 W, load 4 Ω) or stereo (power 300 mW, load 8 Ω). It has a potentiometer for power control and gain control for the left and right channel. SparkFun DEV-14475
Pmod SSR is a module with a semiconductor relay. One GPIO port is required for control, the relay is suitable for operation with up to 48 V, it can be used for devices that draw current up to 6 A. Digilent 410-342
No product available!
No product available!
No product available!
No product available!
relative humidity sensor with integrated temperature sensor for highly accurate measurements at low power. With the TI HDC1080, you can determine the relative humidity of the environment with up to 14 bits of resolution. Digilent 410-347
No product available!
No product available!
No product available!
Pmod ESP32 is a module with the ESP-WROOM-32 system, allowing for WiFi communication, Bluetooth BLE 4.0 and Bluetooth. For communication, the SPI or UART interface is used (selected by means of the slide switch), which were output on the 12-pin Pmod connector. Digilent 410-377
Pmod I2S2 is a module with 24-bit A / C and D / C audio converters derived from standard 3,5 mm Jack connectors. Thanks to them, it is possible to send and receive stereo audio signals using the I2S protocol. Digilent 410-379
Pmod MicroSD is a module with a microSD memory card reader. With the help of the module it is possible to read and write data on the microSD memory card without limiting the file system or the maximum card size. The SPI interface is used for communication. Digilent 410-380
No product available!
The Pmod BLE module is a Bluetooth module with powerful capabilities. Thanks to communication via the UART port, the module can be connected to any platform equipped with this interface. The module is equipped with the Roving Networks RN4870 system, in which a full Bluetooth interface is built-in. Digilent 410-359
No product available!
The Pmod DHB1 uses DRV8833 dual H-Bridge motor driver chip to drive two DC motors or a single stepper motor. 410-259
No product available!
Stereo Power Amplifier