PmodPMON1
ID: 204256
zł61.16
Tax included
zł49.72 tax excl.
Power Monitor
PmodPMON1
Power Monitor, Digilent, RoHS
The PmodPMON1 employs the Analog Devices® AD5112 and ADM1191 to create a system power monitor.
Customers can configure the PMON1 to a wide range of possible alert conditions from the ADM1191 by using the configurable AD5112 potentiometer. The AD5112 upper potentiometer connection ties to DVDD through a filtering ferrite bead and the lower connection connects to GND. The wiper directly connects to the SETV pin on the ADM1191 to allow for the wide range of alert conditions. If an alert condition occurs, LD1 on the PMON1 will illuminate and the alert pin will go to a logic low state.
Key Features:
- Monitor current draws less than 1.058A
- Monitor voltages from 3.16V to 26V on the J3 VIN pin
- DVDD input ranges from 3V to 5.5V
- Standard I2C interface
- Configurable device address allows for up to nine PMON1s in a single system.
Contents:
- PmodPMON1 board
- 4-pin to 2x2-pin MTE Cable and a 6-pin header
Download:
Code: 210-265
204256
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
Development kit with STM32L496ZGT6 microcontroller (ARM Cortex-M4 core) with a built-in ST-Link programmer. Extensive equipment, including: MEMS 6DoF sensor, motor controller, joystick, LED display, 8 LED diodes, RGB LED, audio amplifier, Flash memory QSPI 1 MB, microphone, Arduino connector
zł316.23
24h
Available quantity: 25
Available
Development kit with STM32L496ZGT6 microcontroller with built-in ST-Link programmer. Extensive equipment, including: MEMS 6DoF sensor, motor controller, joystick, LED display, 8 LED diodes, RGB LED, audio amplifier, Flash memory QSPI 1 MB, microphone.
zł249.00
24h
Available quantity: 24
Available
Other products in the same category (16)
Evaluation Board with AD7690, 1xADC, 18-bit, Sampling Rate (Per Second) 400k, Analog Devices, RoHS
zł257.73
4 weeks
No product available!
Evaluation Board with AD7982, 1xADC, 18-bit, Sampling Rate (Per Second) 1M, Analog Devices, RoHS
zł287.82
4 weeks
No product available!
Evaluation Board with AD7693, 1xADC, 16-bit, Sampling Rate (Per Second) 500k, Analog Devices, RoHS
zł287.82
24h
Available quantity: 1
Available
Evaluation Board with CN0332, Magnetoresistive (MR) Rotational Speed Sensor, Analog Devices, RoHS
zł243.54
24h
Available quantity: 1
Available
No product available!
Available
The extension cables let you locate Pmod 6" away from its host board, or use your 12-pin Pmod on a system board with only two 6-pin Pmod headers available. 240-021-2
zł29.69
24h
Available quantity: 4
Available
Useful for securely attaching a Pmod to your project or application; works with any Pmod 0.80" in width. 240-107
zł18.94
3 weeks
No product available!
The Pmod DHB1 uses DRV8833 dual H-Bridge motor driver chip to drive two DC motors or a single stepper motor. 410-259
zł106.04
3 weeks
No product available!
High-speed communication module powered by ADM582E. By communicating with the device via UART, users can take advantage of the RS485 communication protocol with speeds up to 16 Mbps. 410-310
zł191.67
24h
Available quantity: 4
Available
Accessory board designed to provide students a cost-effective, portable, and engaging platform for teaching electronics. With a myDAQ / myRIO, NI Multisim, and a myDigital, you\'ll have everything needed to allow students to design, construct, test basic analog and digital designs. 6002-410-006
zł620.57
3 weeks
No product available!
The extension cable lets you locate your Pmod away from its host board, and the included male gender changer can provide extra connectivity to both system and prototyping boards. 240-021-1
zł26.57
3 weeks
No product available!
Provides a 300 tie breadboard and 50 tie bus bar on an expansion card compatible with the NI myRIO Expansion Port (MXP). 210-283
zł133.81
3 weeks
No product available!
Digital logic level shifter ideal for users who want to supply logic signals following a 3.3V CMOS standard but have an alternate logic level output that is used for other applications, such as JTAG programming. 410-320
zł135.82
3 weeks
No product available!
Graphical display, users may show off graphs, full-color pictures, text, and anything else they want to see by communicating with it through SPI. Digilent 410-323
zł181.94
24h
Available quantity: 2
Available
The Digilent Pmod NAV uses the LSM9DS1 3-axis accelerometer, 3-axis gyroscope, 3-axis magnetometer, plus the LPS25HB digital barometer to provide users with 10-DOF functionality. Digilent 410-326
zł262.11
3 weeks
No product available!
Power Monitor