- Out-of-Stock
Spring for 3D printers 10x25mm (blue)
ID: 1182160
Spring dedicated to the heating table of 3D printers. It allows you to adjust the degree of tightening the knob, and thus enables the proper leveling of the working table
Description
Spring dedicated to the heating table of 3D printers. It allows you to adjust the degree of tightening the knob, and thus enables the proper leveling of the working table. Prevents the table from bending and cushions it. It ensures a stable position of the table during operation, thanks to which it increases the quality and repeatability of the printed elements.
Features
- Outer diameter: 10 mm
- Inner diameter: 5.5 mm
- Length: 25 mm
- Blue color
1182160
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
Nut with M4 thread for screwing the table to the 3D printer
zł7.66
24h
Available quantity: 17
Available
Spring dedicated to the heating table of 3D printers. It allows you to adjust the degree of tightening the knob, and thus enables the proper leveling of the working table. Set of 4 pcs
zł6.20
24h
Available quantity: 13
Available
Other products in the same category (16)
No product available!
No product available!
3DR Radio is a set that allows bidirectional transmission of telemetry data, eg between the RC model (with the APM controller) and a PC. Light and small device in a set with antennas and connecting cables. Radio modules have a power of 100mW (+ 20dBm) and transmit a signal over a distance of 1km.
Retired
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
The I2C electric level conversion module is specifically designed for Banana Pi. The module converts the 3.3V of I2C electric level to 5V level or converts 5V to 3.3V
Retired
No product available!
The Raspberry Pi GPIO Triple Expansion Board converts the single GPIO headers on your Raspberry Pi into three parts. DFR0385
Retired
No product available!
No product available!
No product available!
Dispensing needle for precise application of glue, flux with an internal diameter of 0.2mm and an external diameter of 0.4mm.
Retired
No product available!
A set for building a four-wheel, remote-controlled vehicle. Equipped with a programmable Arduino Uno R3 controller and set of sensors. modARD_02
Retired
No product available!
Spring dedicated to the heating table of 3D printers. It allows you to adjust the degree of tightening the knob, and thus enables the proper leveling of the working table