- Out-of-Stock

The UGEARS dynamometer is an interactive, easy-to-build model that, working on the principle of an air motor, when blown, points to an image symbolizing the task to be performed, assisting in decision making and demonstrating the basic principles of mechanics. UGears 70005
If you are struggling to decide what to do today, the UGEARS Dynamometer is the solution for you. This unique model works on a similar principle to a pneumatic engine, with an added element of interactive play. Just blow on a specific spot and the whole system will start working. The arrow, depending on the applied air pressure, will point to the image symbolizing the task to be performed - bringing meaning and purpose to your day. The UGEARS dynamometer is one of the easiest models to build while demonstrating the basic principles of mechanics, making it a great educational tool and creative toy.
Camera with OV9655 CMOS sensor with a resolution of 1289x1024 px. It communicates via a parallel interface. ArduCAM U6040
No product available!
Printed circuit board and programmed circuit for event counter. AVT3188 A +
No product available!
CAMDENBOSS CBRPC-WHT Dev Board Enclosure, Raspberry Pi Camera, Polystyrene, White
No product available!
No product available!
No product available!
Development board with ST Zio and ST morpho connectors, based on the STM32H745ZI microcontroller. Thanks to the embedded STLINK-V3 programmer, it is possible to program and debug the microcontroller via USB. STMicroelectronics NUCLEO-H745ZI-Q
No product available!
Arduino Ethernet Rev3 WITH PoE - board with ATmega328 microcontroller from the AVR family. The board is equipped with the WizNet5100 Ethernet controller and the PoE power module. Additional equipment includes, among others: micro-SD card slot. A000074
No product available!
No product available!
AVT kit for self-assembly gigatermometer. AVT3155 B
No product available!
Battery: Li-Po; 3.7V; 2000mAh; Outputs: wires with 2-pin JST-PH connector; 5.8 mm x 54 x 60 mm. PRT-08483
No product available!
Seeed studio LoRa / GPS HAT is an extension designed for Raspberry Pi 2 minicomputers (model B) and Raspberry Pi 3. It has a LoRa communication module (868 MHz) and a GPS module. Seeed Studio 113990254
No product available!
No product available!
No product available!
Cytron USB to UART Converter CH340 - USB - UART converter based on the CH340 chip
No product available!
Black microHDMI-HDMI cable with a length of 1 meter. Compliant with HDMI v1.4 specification. Lanberg CA-HDMI-12CC-0010-BK
No product available!
No product available!
The UGEARS dynamometer is an interactive, easy-to-build model that, working on the principle of an air motor, when blown, points to an image symbolizing the task to be performed, assisting in decision making and demonstrating the basic principles of mechanics. UGears 70005