.png)
- Out-of-Stock
Liquid Sample Introduction in ICP Spectrometry
ID: 173438
José-Luis Todoli, Jean-Michel Mermet
Inductively coupled plasma atomic or mass spectrometry is one of the most common techniques for elemental analysis. Samples to be expressed in the form of a sample of problems. Because the sample introduction system can be a limiting factor in the analytical performance, it is crucial to optimize its design and its use. It is the purpose of this book to obtain the best knowledge of the technique.
- Fundamental as well as practical character
- Troubleshooting section
- Flow charts with optimum systems to be used for a given application
1. History-Introduction
2. Specifications of a sample introduction system to be used with an ICP
3. Nebulizers. Pneumatic designs.
4. Chambers spray
5. Desolvation systems
6. Matrix effects
7. Selection and maintenance of sample introduction systems
8. Applications
- Fundamental as well as practical character
- Troubleshooting section
- Flow charts with optimum systems to be used for a given application
1. History-Introduction
2. Specifications of a sample introduction system to be used with an ICP
3. Nebulizers. Pneumatic designs.
4. Chambers spray
5. Desolvation systems
6. Matrix effects
7. Selection and maintenance of sample introduction systems
8. Applications
173438
Other products in the same category (16)
Computer fan housing Raspberry Pi 3, Raspberry Pi 2 model B and Raspberry Pi 1 model B + in dark blue plastic color
Retired
No product available!
Case for the Raspberry PI 2 model B, Raspberry PI 1 model B+ and Raspberry PI 3 computers, manufactured from high quality acrylic. CLEAR
Retired
No product available!
No product available!
No product available!
No product available!
Infrared sensor that allows measurement of distances up to 15cm, has a built-in infrared illuminator, IR receiver and a perimeter of the received signal
Retired
No product available!
Miniature (22x13.5x6mm) WiFi module b / g / n with TCP and UDP protocols operating in standalone and access point modes. 2.0mm goldpin connector. The module is equipped with a UART interface, it is also possible to control GPIO lines (also as PWM). Powered by 3.3V. Antenna: copper wire
Retired
No product available!
Ultra miniature WiFi b/g/n module, equipped with UART, SPI, PWM and GPIO interfaces. The ability to work as an access point and in standalone mode. 3.3V power supply.HF-LPT200-1
Retired
No product available!
This transducer is about 45mm in diameter and has 4Ω impedance and should be run at about 5W
Retired
No product available!
SPIRIT1 868 MHz low power RF module with integrated microcontroller
Delivery date unknown
No product available!
Read/Write analog front end for 125 kHz RFID Basestation, SOIC16, EM Microrlectronic, RoHS
Retired
No product available!
Bitscope Micro is a miniature measuring instrument with a USB interface, it can act as an 8-channel logic analyzer (40MS / s, 3.3V or 5V) or a 2-channel oscilloscope (bandwidth up to 20MHz). In addition, Bitscope can generate a clock signal as well as sinusoidal, triangular, rectangular and saws
Retired
No product available!
High performance WLAN USB module which enables the Raspberry Pi to connect to a Wi-Fi network
Retired
No product available!
32-bit microcontroller from the STM32F4 family with ARM Cortex-M4 core, 256kB Flash, 128KB SRAM, I2C, HDMI-CEC, Irda, LIN, SPI, UART / USART, USB, DMA, PWM, 1.7 ... 3.6V, 64-LQFP
Retired
No product available!
32-bit microcontroller from the STM32F4 family with ARM Cortex-M4 core, 512kB Flash, 128KB SRAM, I2C, HDMI-CEC, Irda, LIN, SPI, UART / USART, USB, DMA, PWM, 1.7 ... 3.6V, 64-LQFP
Retired
No product available!
32-bit microcontroller from the STM32F4 family with ARM Cortex-M4 core, 512kB Flash, 128KB SRAM, I2C, HDMI-CEC, Irda, LIN, SPI, UART / USART, USB, DMA, PWM, 1.7 ... 3.6V, LQFP-144
Retired
No product available!
José-Luis Todoli, Jean-Michel Mermet