SIM300D

Silicone protective case for the Huskylens vision module. It was made of a soft and flexible material, it perfectly fits the shape of the tile. DFRobot FIT0647

Module with a CCS811 air quality sensor for measuring the concentration of carbon dioxide (CO2) and volatile organic compounds (VOC) in the air. It communicates via the I2C interface. DFRobot SEN0339

Evaluation kit with SiFive Freedom E310 microcontroller with RISC-V (ISA) architecture. It includes 32MB QSPI flash memory, NXP K22 ARM Cortex-M4 microcontroller for USB support and JTAG interface, Qwiic and USB Type-C connector. SparkFun DEV-15594

Cable with a length of 150 mm, on one side terminated with a Qwiic connector, and on the other side with single female goldpin connectors. It allows you to connect Qwiic modules, e.g. with development board. SparkFun CAB-14988

Extension module for Raspberry Pi designed to build the user interface. It is equipped with a 2.4-inch TFT LCD display, microphones, speaker, buttons, joystick and RGB LEDs. SparkFun DEV-16653

Adapter board from SODIMM200-2.5 to 2.54mm connectors

The expansion module to support two cameras is designed for Raspberry Pi minicomputers. The board allows you to connect two cameras via CSI connectors to one minicomputer connector. ArduCAM B016601

Evaluation kit with LittleBee GW1N-1 FPGA chip. Offers 1152 LUTs and 864 Flip-Flops (FF). The board has an FPC connector for the display and a USB type C. Sipeed Lichee Tang Nano

Video splitter for connecting one input device to 2 receivers. Maximum 4K resolution supported. Lanberg SPV-HDMI-0002

Video splitter for connecting one input device to 4 receivers. Maximum 4K resolution supported. Lanberg SPV-HDMI-0004

Video splitter for connecting one input device to 8 receivers. Maximum 4K resolution supported. Lanberg SPV-HDMI-0008

Video switch that allows you to connect 5 input devices to one HDMI receiver. The input signal can be selected using a button on the casing or the included remote control. Lanberg SWV-HDMI-0005

A set of 8 knives, including 4 knives with broken blades and 4 special-purpose knives. Vorel 76280

Module with an analog temperature and humidity sensor based on the SHT10 system. It is characterized by high reliability and stability with low energy consumption. It is compatible with 3.3V and 5V controllers. DFRobot DFR0066

Module with a CCS811 air quality sensor for measuring the concentration of carbon dioxide (eCO2) and volatile organic compounds (TVOC) in the air. It communicates via the I2C interface (Gravity connector). DFRobot SEN0318

Module with a gesture and touch sensor. It recognizes 7 types of gestures and has 5 touch buttons. It is supplied with a voltage ranging from 3.3 V to 5 V and communicates via UART. DFRobot SEN0285