- Out-of-Stock
AVT701 / E3 - Set of resistors - 800 pieces from the E3 series (multiples: 10, 22, 47) -Ω, kΩ, MΩ.
The AVT701 / E3 set includes the most popular pulled resistors (with wire leads) with a power of 0.25 W and 5% tolerance. A total of 800 resistors (+/- 8 pcs)
The kit is especially recommended for beginner electronics, but also for service technicians and constructors
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
No product available!
No product available!
HK Serpent 2 Mini V-Hull Racing Boat 360mm (RTR) (38112)
No product available!
No product available!
Module with a 3-color (yellow, black, white) e-Paper display with a diagonal of 4.2" and a resolution of 400x300 px. SPI interface. Waveshare 4.2inch e-Paper Module (C)
No product available!
Low cost programmer for STM32 and STM8 microcontrollers fully compatible
with the ST-Link V2
No product available!
Waveshare AlphaBot, a basic set for building an Arduino-based robot
No product available!
Assembled start-stop time relay. Ideally suited as a controller for lighting, heating or ventilation ventilation. AVT1879 C
No product available!
No product available!
Quad-band GSM/GPRS module operating at 850/900/1800/1900MHz frequencies. It has integrated TCP/IP, UDP, FTP, PPP network protocols. Quectel M95FA
No product available!
3.0 GHz input high division (by 256, 128, 64) prescaler IC for analog DBS tuners, SSOP8, CEL, RoHS
No product available!
3.5 "TFT display with touch panel, transparent housing and 16 GB SD card for Raspberry Pi 3. ArduCAM U470302
No product available!
No product available!
Orange Pi Plus 2e is a computer with SoC Alwinner H3 (4 cores, Cortex-A7, Mali400MP2 GPU), has 2 GB of RAM, 16GB of integrated eMMC memory and WiFi 802.11 b / g / n module. There are three USB 2.0 ports, one ethernet port (1 Gigabit), a 40-pin GPIO connector and a micro-SD card slot
No product available!
The SparkFun Qwiic Shield for Thing Plus provides an easy-to-assemble way to add the SparkFun Qwiic ecosystem to any development board with the Thing Plus Footprint. It connects the I2C bus (GND, 3.3V, SDA, and SCL) on your Thing Plus to four SparkFun Qwiic connectors. Sparkfun DEV-16138
No product available!
No product available!
No product available!
ARK terminal connector spring 4-pin, pitch 5.00 mm, non-detachable
No product available!
START KIT - E3 RESISTORS - 800pcs