- Out-of-Stock
AVT1617 A +
ID: 190140
WAGON LIGHTING WITH DCC DECODER - PRINTED BOARD AND CONTROLLED LAYOUT
WAGON LIGHTING WITH DCC DECODER - PRINTED BOARD AND CONTROLLED LAYOUT
Producer: AVT
The system allows illuminating the models of wagons on the railway model. The DCC decoder described in EP9 / 2009 was used in it. The elements responsible for the reception of information from the tracks, the power part and the programming interface are standard. The output circuit was differently designed. Instead of a typical operational amplifier controlling the drive motor, FET transistors were used. They directly control the LED diode assemblies. In addition to the interior lighting (compartments and vestibules), end-of-line lamps can be switched on and off.
The device is especially recommended for lovers of model railway
Selected parameters:
- independent switching on and decoder only in zones of intervals and atria
- end composition lighting
- independent regulation of brightness in each zone - 256 steps
- programming on the service track and on the model
- load capacity 4x200mA
- short addressing (1-127)
- 12V power supply
- a printed circuit board, programmed layout and documentation in the set
- Detailed description in
Download
190140
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
Development platform powered by Exynos5 Octa Cortex™-A15 1.4Ghz quad core and Cortex™-A7 quad core CPUs
Retired
No product available!
No product available!
LCD 4x12, 37x48.5mm, LED backlight (RGB), FSTN, 5.88x2.90mm character
Retired
No product available!
No product available!
No product available!
ROSA3D filament made of high-quality ASA polymer. 0.7 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D ASA Natural
Retired
No product available!
32-bit ARM Cortex-M3 microcontroller; 32 kB flash, 8 kB SRAM; USB device, HVQFN33
Retired
No product available!
The RGB LED ruler has 8 programmable LEDs WS2812B with a built-in control system. It is possible to set a specific color for each diode. The module has an IN input for controlling and an OUT output to which further light points or other modules from WS2812B can be connected. The supply voltage is from 3.5 to 5.3 V, and the input voltage +/- 0.5 V of the supply voltage
Retired
No product available!
5V / 3.1A eXtreme power supply with microUSB plug for all Raspberry Pi computers (including Pi 3 model B and Pi 3 model B +)
Retired
No product available!
Espressif\'s ESP32-S3-WROOM-1 WiFi and Bluetooth LE module board, offering 8 MB Flash memory and 8 MB PSRAM. Espressif Systems ESP32-S3-DevKitC-1-N8R8
Retired
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
The board with the RP2040 microcontroller equipped with two ARM Cortex-M0 + cores operating at 133 MHz, 256 kB RAM. The board also has 16 MB of QSPI flash memory. The system can be programmed in C/C++ or microPython. SparkFun DEV-17717
Retired
No product available!
WAGON LIGHTING WITH DCC DECODER - PRINTED BOARD AND CONTROLLED LAYOUT