AVT5190 B

The system is intended for wheeled and floating modelers. The regulator was designed for remotely controlled models, mainly cars. High-current DC brush motors are used to drive them. While driving, they must work in both directions - therefore a bi-directional regulator is required to control them. Such devices from renowned modeling companies are relatively expensive. Meanwhile, for a recreational ride, it is enough to create a system made by yourself. It does not meet the high racing standards, but it is relatively cheap and has good parameters (including the BEC system). The microcontroller, which was used in it, was programmed in Bascom language. This allows you to easily make your own changes.

The device is particularly recommended for circular and floating modelers

Selected parameters:

• bi-directional regulator
• non-linear gas characteristics, gentle engine start
• operation status indication - LED diodes
• BEC 5V / 1.5A
• quick calibration with a single button
• Neutral width and position adjustment, work option as a one-way controller
• proportional brake
• low voltage supply, cut-off signal, engine shutdown without signal
• Thermal protection
• 6-10 Ni-Mh or Ni-Cd goal or 2-3 Li-poly or Li-ion target, automatic target amount detection
• Maximum continuous current: 20A
• Maximum instantaneous current: 40A
• Minimum number of engine turns: 18
• Internal resistance: 0.027ohms
• in the set there is a printed circuit board, programmed layout, set of elements and documentation
  
  A detailed description in
  EP 6/09