- Out-of-Stock
AVT3026 A +
ID: 190238
ELECTRONIC HIGROSTAT - PRINTED PLATES AND PROGRAMMED LAYOUT
ELECTRONIC HIGROSTAT - PRINTED PLATES AND PROGRAMMED LAYOUT
Producer: AVT
The device is designed to control the level of moisture in the air. It can be useful in greenhouses, in terrariums and even at home - for controlling an air humidifier, eg in a bedroom. The sensor used is a ready, integrated and calibrated measuring element. It eliminates the need for calibration and increases the reliability of operation. Settings, readings and control of device operation are possible thanks to clear, seven-segment LED displays.
The device is especially recommended in places where it is necessary to monitor the air humidity
Selected parameters:
- humidity control in the range of 10-95%
- ready, integrated sensor
- two seven-segment LED displays
- additional LED control diodes
- sound signaling
- executive element - relay
- power supply - 230Vac
- a printed circuit board, programmed layout and documentation in the set
- Detailed description in
Download
190238
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
The Counter is a stylised educational model, an interactive study guide to the mechanism, only for learning its essentials and principles of working. It registers repetitive actions. It is an integral part of a device called an “Odometer”. The model has three cylinder gears with numbers from 0 to 9 and a Geneva Drive. UGears 70130
Retired
No product available!
No product available!
PCB and programmed circuit for the switch controlled by any remote control. AVT3125 A +
Retired
No product available!
Pololu Serial 8-Servo Controller (partial kit)
Retired
No product available!
Female terminal block, 6-pin. Pitch 3.5mm. Height 15.6mm. KF2EDGK
Retired
No product available!
Permanent cylindrical neodymium magnet with a diameter of 2 mm and a height of 2 mm.
Retired
No product available!
MYIR MYIR MYS-7Z010-LC is a set of elements with a single board computer based on the Xilinx XC7Z010-1CLG400C (Zynq-7010) system. This system consists of a dual-core processor based on Cortex-A9 core, which can operate at a maximum frequency of 667 MHz. The computer is equipped with 512 MB of DDR3 SDRAM, 4 GB of eMMC memory and 16 MB of QSPI Flash memory
Retired
No product available!
No product available!
Laser distance meter with a range of up to 40m and a resolution of 1mm. Equipped with a 2" display. It can measure length, area and volume with the push of a button. Uni-T LM40
Retired
No product available!
No product available!
Graphic LCD 128x64, LED backlight (Yellow/Green), enhanced temperature range; replaced A-series, built with COG display, PCB 93x70mm, RoHS
Retired
No product available!
Module with LED strip designed for the MyoWare 2.0 muscle tension sensor. Equipped with a LiPo battery, it allows you to build portable devices. SparkFun DEV-18387
Retired
No product available!
16x2 Character LCD with LED Backlight (Parallel Interface), Black on Green
Retired
No product available!
AVT kit for self-assembly of a miniature 24V power supply module. AVT1913 / 24 B
Retired
No product available!
The ICE40HX1K-STICK-EVN is an easy to use, small size board that allows rapid prototyping of system functions at a very low cost using iCE40 FPGA. This board has a high performance, low power iCE40HX1K FPGA onboard and has a USB thumb drive form factor.
Retired
No product available!
No product available!
ELECTRONIC HIGROSTAT - PRINTED PLATES AND PROGRAMMED LAYOUT