AVT1337 A

Development board with ST Zio and ST morpho connectors, based on the STM32L552ZE microcontroller. Thanks to the built-in programmer compatible with ST-Link/v2-1, it is possible to program and debug the microcontroller via the USB connector. STMicroelectronics NUCLEO-L552ZE-P-Q

Module with 9-axis IMU BMX160 sensor (accelerometer, gyroscope and magnetomet) and BMP388 pressure/temperature sensor. Communication via the I2C interface. DFRobot SEN0252

Minicomputer Rockchip RK3328 quad-core processor and 1GB RAM. The module has two Ethernet ports, USB 2.0 port and USB type C. It is equipped with a microSD card slot. The kit includes a CNC metal case. FriendlyELEC NanoPi R2S

150W lead and lead free soldering pot. It serves, among others for tinning/soldering of cable ends.

Set of 6 insulating tapes in the following colors: red, yellow, yellow-green, green, blue and black.

Vision Edge computing platform with ARM Cortex-A53 1.2 GHz 64-bit quad-core processor, ARM Cortex-R5 600 MHz dual-core processor, embedded Mali400 graphics processor and FPGA chip. MYIR VECP Starter Kit

The minicomputer with the Intel Celeron J4115 quad-core processor (2.5 GHz, 64-bit) has 2 slots for DDR4 RAM modules. Additionally, it is equipped with, among others: Gigabit Ethernet, HDMI 2.0 port and Display Port 1.2 4K/60Hz, four USB sockets, 24 GPIO, PCI-e slot, two SATA3 connectors. Rev-B+. ODROID H2+

LPCXpresso55S16 evaluation kit with LPC55S16 microcontroller with ARM Cortex-M33 core. The board contains built-in LPC-Link2, audio subsystem, accelerometer, USB interfaces and Arduino connectors. NXP LPC55S16-EVK

The MIMXRT1062DVL6A Processor Evaluation Kit, which runs up to 600 MHz, has 256 MB of SDRAM, 512 MB of Flash and 64 QSPI Flash. NXP MIMXRT1060-EVK

Starter kit with the Kinetis K32 L2B microcontroller, integrated with the OpenSDA programmer-debugger, LCD display, accelerometer and MEMS magnetometer and USB connector. Conclusions compatible with Arduino. NXP FRDM-K32L2B3

Wired mouse with a precise optical sensor. It has a button to change the resolution in four levels: 800/1200/1600/2400 DPI. 1.8m cable with USB plug. Natec NMY-0667

Easy PET-G filament in black with a diameter of 1.75 mm. 0.85 kg of filament is wound on a spool. Fiberlogy Easy PET-G Black

Easy PET-G filament in pure transparent with a diameter of 1.75 mm. 0.85 kg of filament is wound on a spool. Fiberlogy Easy PET-G Pure Transparent

Easy PET-G filament in silver with a diameter of 1.75 mm. 0.85 kg of filament is wound on a spool. Fiberlogy Easy PET-G Silver

Easy PET-G filament in white with a diameter of 1.75 mm. 0.85 kg of filament is wound on a spool. Fiberlogy Easy PET-G White

Easy PLA filament in graphite, 1.75 mm in diameter. 0.85 kg of filament is wound on a spool. Fiberlogy Easy PLA Graphite