- Out-of-Stock
Audiophile 200w amplifier - set for self-assembly. As every audiophile-electronics knows - good amplifiers are never too much. We present a system made entirely on discrete elements. Thanks to this, it is very easy to 'tweak' it and adjust it to your own needs. Performance of an amplifier with a power above 100W is not easy. It requires the use of appropriate elements and, above all, a correctly made plate. This is the layout presented. It is a modern classic with completely symmetrical signal transmission - from entry to the final stage. The power amplifier uses two pairs of HEXFET power transistors.
The device is especially recommended for all self-building sound devices - lovers of good sound
Selected parameters:
Manufacturer
Responsible person
The I2C electric level conversion module is specifically designed for Banana Pi. The module converts the 3.3V of I2C electric level to 5V level or converts 5V to 3.3V
No product available!
BPI AD/DA extend module with the PCF8591 single-chip, single-supply low-power 8-bit CMOS data acquisition device with four analog inputs, one analog output and a serial I2C-bus interface
No product available!
No product available!
5dB antenna for the Banana Pi R1 router in the version with 300Mps wifi and five LAN 100/1000 ports.
No product available!
STM32F103 programming cable for Open Debugger Burn Board and Banana Pi G1 connection
No product available!
CC3200 programming cable for Open Debugger Burn Board and Banana Pi G1 connection
No product available!
CC2530 and CC2540 programming cable for Open Debugger Burn Board and Banana Pi G1 connection
No product available!
It is a standard audio-video cable, which can be successfully used to connect Banana Pi M1 or Raspberry Pi 1 model B and A. Cable length is 98 cm, has two ends of the chinch type.
No product available!
COM-11964 Button a white economy grade 100mm diameter (outside diameter) dome illuminated push button comes with an LED, securing nut and a long life horizontal microswitch.
No product available!
Cobbler Plus - adapter enabling connection of GPIO Raspberry Pi A +, B + and Pi 2 lines to the contact plate (2.54 mm). The version is assembled. Adafruit 2029
No product available!
T-Cobbler Plus - adapter enabling connection of GPIO Raspberry Pi A +, B + and Pi 2 lines to the contact plate (2.54 mm). Goldpin connectors are included, for self-assembly. Adafruit 1989
No product available!
FPC tape length 250 mm, 50 lines, pitch 0.5 mm. Adafruit 1682
No product available!
μHex is the first low-power controller which is compatible with Arduino. It is very suitable for the battery power supply environment. A 210mAh CR2032 cell battery could make it work 60 days long. DFR0343
No product available!
Complete Robot Kit with Romeo V2 All-in-one controller, Sharp GP2Y0A21 Distance Sensor, 9g micro servo which allow you to install sensors, servos and even do some prototypings. KIT0071
No product available!
The Leonardo ETH is a microcontroller board based on the ATmega32U4 and the new W5500 TCP/IP Embedded Ethernet Controller (datasheet).
No product available!
The DE0-Nano-SoC Development Kit presents a robust hardware design platform built around the Altera System-on-Chip (SoC) FPGA, which combines the latest dual-core Cortex-A9 embedded cores with industry-leading programmable logic for ultimate design flexibility
No product available!
AUDIOFILSKI 200W AMPLIFIER - A KIT FOR INDEPENDENT INSTALLATION