- Out-of-Stock
![AVT1430 A AVT1430 A](https://kamami.pl/6172-large_default/avt1430-a.jpg)
ATMEGA8 W AVT992 - PRINTED PLATE
A mandatory supplement to the AVT992 kit
Adapter enabling the use of the ATMEGA8 processor on the test board
The device is especially recommended for people who want to learn programming microprocessors and all who are testing systems based on ATMEGA processors
Selected parameters:
Printed circuit board and programmed system for the alarm control panel cooperating with the motion sensor. AVT1925 A +
No product available!
Needle bending needle, for precise glue application, Flux 0.81mm internal diameter and 1.26mm outside diameter
No product available!
Alphanumeric display OLED 16 characters x 2 lines, with built-in controller WS0010, communicating via 6800 interface, optionally 8080 or SPI. Winstar WEH001602AR
No product available!
No product available!
Spring dedicated to the heating table of 3D printers. It allows you to adjust the degree of tightening the knob, and thus enables the proper leveling of the working table
No product available!
No product available!
BPI AD/DA extend module with the PCF8591 single-chip, single-supply low-power 8-bit CMOS data acquisition device with four analog inputs, one analog output and a serial I2C-bus interface
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
Neodymium rectangular magnet with dimensions of 10x5mm a and a height of 5 mm.
No product available!
ATMEGA8 W AVT992 - PRINTED PLATE