AVT1617 B

The system allows illuminating the models of wagons on the railway model. The DCC decoder described in EP9 / 2009 was used in it. The elements responsible for the reception of information from the tracks, the power part and the programming interface are standard. The output circuit was differently designed. Instead of a typical operational amplifier controlling the drive motor, FET transistors were used. They directly control the LED diode assemblies. In addition to the interior lighting (compartments and vestibules), end-of-line lamps can be switched on and off.

The device is especially recommended for lovers of model railway

Selected parameters:

• independent switching on and decoder only in zones of intervals and atria
• end composition lighting
• independent regulation of brightness in each zone - 256 steps
• programming on the service track and on the model
• load capacity 4x200mA
• short addressing (1-127)
• 12V power supply
• in the set there is a printed circuit board, programmed layout, set of elements and documentation
  
  Detailed description in
  EP 5/11