- Out-of-Stock
AVT1754 B
ID: 208328
BATTERY CHARGER NICD AND NIMH - KIT FOR INDEPENDENT INSTALLATION
BATTERY CHARGER NICD AND NIMH - KIT FOR INDEPENDENT INSTALLATION
Producer: AVT
Battery charger NiCd and NiMH
The system was assembled on a one-sided PCB with dimensions of 60x88mm. The charger should be powered with a stabilized voltage of + 5V. In the model system, a USB interface was used for this purpose, which allows the charger to be powered from a computer, laptop or network charger for mobile phones. The current consumption is approx. 30mA greater than the set charging current.
The set includes a printed circuit board, a set of elements and documentation.
A detailed description in EP8 / 13 or 
208328
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
No product available!
ROSA3D filament made of high-quality PLA granules. 3 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D PLA Starter Black
Retired
No product available!
No product available!
AVRSYN2 - MUSICAL SYNTHESIZE ON EIGHT-LINK CONTROLLER - PLATE AND PROGRAMMED LAYOUT
Retired
No product available!
Assembled, accurate clock with 20mm display set by means of GPS. AVT5522 / 1 C
Retired
No product available!
Robert Triboulet, Paul Siffert
Delivery date unknown
No product available!
No product available!
Crimping tool HT106L by Prosonic, supports connectors: F59, F11, F6, UHF58, HF8
Retired
No product available!
Cable with USB type A and microUSB plugs type B 2.0, cable length 0.5 m. LANBERG CA-USBM-10CC-0005-BK
Retired
No product available!
Spring dedicated to the heating table of 3D printers. It allows you to adjust the degree of tightening the knob, and thus enables the proper leveling of the working table
Retired
No product available!
AVT kit for self-assembly of the DC motor driver for the drive. AVT5565 B
Retired
No product available!
Printed circuit board for the Lattice PLP programmer
Delivery date unknown
No product available!
The module with the ACS725 current sensor with a direct current measuring range up to 10 A. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020616
Retired
No product available!
No product available!
RS485 PADS - RELAY OUTPUT CARD - ASSEMBLED AND COMMISSIONED KIT
Retired
No product available!
No product available!
BATTERY CHARGER NICD AND NIMH - KIT FOR INDEPENDENT INSTALLATION