- Out-of-Stock

Descriptions of ISP programmers for AVR microcontrollers can be found on the Internet very much. However, the vast majority of them do not work with the USB port. Few supporters of this standard are designed based on the FT232 converter. This is the layout presented. It was created for the electronics using laptops - the standard is that there is no LPT connector, through which earlier versions of programmers were supported.
The device is especially recommended for all programming AVR microcontrollers
Selected parameters:
Download
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
No product available!
No product available!
No product available!
Small, white-on-black OLED 128x32 monochrome display designed for Teensy development board, controlled with the popular SSD1306 IC. SparkFun LCD-14048
No product available!
A module with a spectrum sensor that operates in the visible light range (450-650 nm). It allows you to measure and characterize a light source or check how the tested surface absorbs or reflects light at specific wavelengths. Pimoroni PIM412
No product available!
No product available!
POWER METER OF EFFECTIVE AUDIO AMPLIFIER - PROGRAMMABLE - PLATEBOARD AND PROGRAMMED LAYOUT
No product available!
Expansion board for STM32 Nucleo with NFC card reader based on the ST25R3916 chip. The board has an Arduino Uno R3 compatible connector and can be combined with STM32 Nucleo boards. STMicroelectronics X-NUCLEO-NFC06A1
No product available!
Baby Orangutan B-328 + USB AVR Programmer Combo
No product available!
No product available!
The ToolkitRC TK41400 adapter splits a single XT60 input into two XT60 male outputs. It facilitates power sharing for RC systems without the need for soldering or additional cables. Ideal for setups requiring multi-device power distribution from a single battery.
No product available!
ROSA3D filament made of high-quality PLA granules. 0.5 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D PLA Starter Glow in the Dark Blue
No product available!
Li-Ion battery type 18650 with a nominal voltage of 3.6 V and a capacity of 3200 mAh. Akyga AKY0926
No product available!
No product available!
Pre-installed Ubuntu 16.04 or latest version. eMMC Version 5.0 interface or higher version from Samsung. JEDEC/MMCA version 5.0 : HS400 interface with 8bit DDR mode. The eMMC chipset is only compatible with Amlogic S905 and S805 series(ODROID-C1+ / C0 / C2)
No product available!
No product available!