- Out-of-Stock
CONTROLLER OF THE HEATING SOLDERING POWER 230V - PLATE AND PROGRAMMED LAYOUT
A classic soldering iron supplied with mains voltage has the advantage that it does not need a station controlling its work. It is easy to use - just plug into the socket, and also a lot cheaper than the set. The disadvantage is the lack of temperature regulation of the tip, which often results in poor quality of solders and overheating of the connected elements.
We offer an inexpensive and uncomplicated regulator that will allow you to easily adjust the tip temperature to your current job. This group power controller can also be used to control small heating devices.
The device is especially recommended for electronics and electricians - people working with a soldering iron in hand
Selected parameters:
Manufacturer
Responsible person
Module with Xilinx Artix-7 100T system, 32MB FLASH memory and 8MB HyperRAM memory. TE0725-03-100-2C
No product available!
Module with Xilinx Artix-7 100T system and 32MB FLASH memory. TE0725LP-01-100-2C
No product available!
Module with Xilinx Artix-7 100T system and 32MB FLASH memory. TE0725LP-01-100-2D
No product available!
Module with Xilinx Artix-7 100T system and 32MB FLASH memory. TE0725LP-01-100-2L
No product available!
Base plate designed to work with TE0808 and TE0803 modules. It allows you to connect the module to external connectors and interfaces. TEBT0808-01
No product available!
Base plate designed to work with TE0745 modules. TEB0745-02
No product available!
Base plate for Trenz Electronics 4x5 cm modules, e.g. TE0741, TE0712. The board allows connecting to the module interfaces: USB, Ethernet, JTAG. TE0705-04
No product available!
Base plate for Trenz Electronic 4 x 5 cm modules. It allows you to connect an FPGA system through board-to-board connections to external peripherals to test and develop software. TE0701-06
No product available!
UltraITX + base board designed to work with TE0808 UltraSOM + MPSoC modules. It allows you to connect the module to external connectors and interfaces. TEBF0808-04
No product available!
TEBA0841 is a base plate for Trenz Electronic 4 x 5 modules, e.g. TE0741 series. The FPGA input / output ports can be connected directly to the periphery via two 50 pin goldpin connectors. TEBA0841-01
No product available!
TE0706 is a base plate for Trenz Electronic 4x5cm Muduors. It allows you to connect USB, JTAG and Ethernet interfaces. TE0706-02
No product available!
Base plate for Trenz Electronics modules 4 x 5 cm, eg for TE0741. The board allows connecting to the module interfaces: USB, Ethernet, JTAG, UART. TE0703-05
No product available!
USB TO UART solution with USB Type A connector, Waveshare
No product available!
No product available!
The second version of the clock synchronization signal receiver, transmitted with AM modulation (DCF77). The built-in MAS6180 system allows you to receive timing frames from a time pattern using a carrier frequency of 77.5 kHz. Thanks to this module, it is possible to create a clock with automatic date and time synchronization. The module has a ferrite antenna. modDCF77 v2
No product available!
Pyboard is a compact development board that allows you to use the MicroPhyton software. Min. 3-axis accelerometer (MMA7670), diodes, monostable buttons and microSD memory card slot. Adafruit 3497
No product available!
CONTROLLER OF THE HEATING SOLDERING POWER 230V - PLATE AND PROGRAMMED LAYOUT