AVT1564 A

Flex Cable for Raspberry Pi Camera - 200mm / 8". Adafruit 1647

Useful for securely attaching a Pmod to your project or application; works with any Pmod 0.80" in width. 240-107

MYIR MYC-C7Z010 is a single board module based on the MYC-C7Z010 chip. This system consists of a dual-core processor based on the Cortex-A9 core (667 MHz) and the Artix-7 FPGA chip. The board has 1 GB of DDR3 SDRAM, 4 GB of eMMC memory and 32 MB of QSPI Flash memory. The board is equipped with numerous peripherals, the outputs of which have been led out on two 140-pin connectors.

LEGO 31313 Mindstorms EV3

AVT kit for self-assembling LEDs, contains a set of elements. AVT1844 B

Assembled AVT set, Christmas, shining Christmas tree LED. AVT1844 C

The sensor detects dangerous carbon monoxide and carbon monoxide, signals a gas leak and the presence of carbon monoxide in rooms. URZ0409

Female-female 10-core connection cable, 15 cm long with connectors of 1.27 mm pitch. Adafruit 1675

1MΩ rotary potentiometer. RM065.

32GB microSDHC Memory Card with SD Adapter, class 4, Kingston

The Pmod TMP3 is an ambient temperature sensor built around the Microchip TCN75A. Users may configure the output through I²C to up to 12 bits of resolution as well as setting a trigger to occur when a user defined temperature threshold is reached.. Digilent 410-287

The Pmod DHB1 uses DRV8833 dual H-Bridge motor driver chip to drive two DC motors or a single stepper motor. 410-259

Development kit chipKIT DP32 equipped with PIC32MX250F128B microcontroller (40/50 Mhz, 128 kB Flash, 32 kB RAM), prototype area with solder pads, potentiometer, 4 LED diodes, 2 buttons and soldering pads for EEPROM memory and analog temperature sensor. Digilent 410-280P-KIT

large 14x21 hole prototyping area on an expansion card compatible with the myRIO Expansion Port (MXP). 6002-210-008P

The set of key components in the myParts Kit encourages hands-on experimentation with breadboards of basic circuitry, helping to make learning productive and enjoyable for beginners and more advanced students alike. Hobbyists and independent developers will also find the kit useful for investigating their design concepts. 6002-240-001P-KIT

Accessory board designed to provide students a cost-effective, portable, and engaging platform for teaching electronics. With a myDAQ / myRIO, NI Multisim, and a myDigital, you\'ll have everything needed to allow students to design, construct, test basic analog and digital designs. 6002-410-006