- Out-of-Stock

This 24-inch (600-mm), flat cable can be used to extend the leads of many common RC hobby servos. It has 22-AWG wires terminated on one end by a “JR”-style male connector and on the other by a “JR”-style female connector.
This servo extension cable has three 22-AWG wires joining a male JR connector and a female JR connector, which means it is compatible with almost all of the RC servos we sell (you can assume our servos have female JR connectors unless the servo’s product page specifically says otherwise). The connectors have gold-flashed contacts on a 0.1" spacing.
Note: The cable’s female connector is the same as what is found on most generic servos and fits nicely with 0.1" male headers, but is often referred to as “male” in the RC hobby industry. Likewise, the cable’s male connector is often referred to as “female” in the hobby industry because of the outer shroud, even though it internally consists of three male pins. The pictures below show the cable connectors labeled with our gender convention.
|
|
The shrouded male connector on these cables is not compatible with Futaba-style connectors. You can get a Futaba female connector to fit by shaving down its polarizing tab. Alternatively, we have slightly different flat and twisted versions of these cables that have the same female JR connector paired with a male Futaba J connector, which means each end is compatible with both JR and Futaba connectors.
We also sell flat and twisted female-to-female servo extension cables.
![]() |
Micro Maestro 6-Channel USB Servo Controller (Assembled) |
![]() |
Servo Extension Cable 24" Female - Female |
![]() |
USB Cable A to Mini-B 6 ft. |
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
No product available!
No product available!
Bluetooth 2.0 + EDR module based on RN42. It communicates via the UART interface. SparkFun WRL-12577
No product available!
FiberFlex 30D filament in Graphite with a diameter of 1.75 mm. 0.85 kg of filament is wound on a spool. Fiberlogy FiberFlex 30D Graphite
No product available!
No product available!
No product available!
No product available!
No product available!
Adjustable USB load displaying voltage and current consumption of connected devices. The load can draw current up to 3 A. The voltage is measured in the range 3.5 ... 21V, current 0 ... 4A. It is also possible to measure cell capacity
No product available!
PCB with programmed system for slow brightener for 12V LED strips. AVT1975 A +
No product available!
No product available!
No product available!
No product available!
AVT kit for self-assembly of LED strip driver with time switch. AVT1867 B
No product available!
The controller module with relay outputs, powered by 12-24V DC, is ideal for remote control of electrical devices in various automation systems. SwitchBoxD DC DIN
No product available!
No product available!