- Out-of-Stock
The Sanyo LB1836M is a great low-voltage dual motor driver (dual H-bridge) that we use in our micro dual serial motor controller and original Orangutan robot controllers. The low-voltage operation and relatively high peak current of 1 A make it an attractive option for those wanting to build small motion control systems powered by one or two Li-based cells or a few NiMH cells.
The Sanyo LB1836M is a dual low-voltage H-bridge that can be used for bidirectional control of two DC motors or one bipolar stepper motor. With an operating voltage as low as 2.5 V for logic and 1.8 V for the motor(s), this controller is great for small motors powered from a single Li-based battery or 2-6 NiMH or alkaline cells. The peak current is up to 1 A per channel, but thermal dissipation usually limits the available continuous current to around 0.5 A (this depends on the PCB layout and heat sinking).
The motor driver features thermal shutdown that can help the chip withstand over-current and short-circuit situations. The IC is only available in a surface-mount package, but the 1.0 mm pitch is relatively accessible even with a standard soldering iron, making it an attractive option for those wanting to build small motion control systems.
![]() |
TB6612FNG Dual Motor Driver Carrier |
![]() |
QTR-1RC Reflectance Sensor |
![]() |
SN754410 Motor Driver IC |
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
No product available!
Arduino UNO set based on the ESP32 WiFi module. The module was designed for cooperation with Arducam 2 MPx and 5 MPx cameras. ArduCAM B0105
No product available!
No product available!
No product available!
Printed circuit board for a practical workshop power supply. AVT3172 A
No product available!
The stabilizer module is used to stabilize the output voltage at an appropriate level and filter interference. The module can be supplied with voltage up to + 16V, and the output voltage is + 3.3V. MOD-06 / 3V3.Z
No product available!
No product available!
The module with an incremental encoder with channels A and B. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 103020030
No product available!
No product available!
Digital audio level indicator consisting of 56 LEDs per channel. Powered by a micro USB connector, it can work with audio players, telephones or computers or display the audio level on the basis of reading from the built-in microphone
No product available!
An extension module to support two cameras designed for Raspberry Pi minicomputers. The board allows you to connect two cameras via CSI connectors to one connector of the minicomputer. ArduCAM B0195
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!