- Out-of-Stock
![Pololu 1480 - Flammable Gas & Smoke Sensor MQ-2 Pololu 1480 - Flammable Gas & Smoke Sensor MQ-2](https://kamami.pl/8873-large_default/pololu-1480-flammable-gas-amp-smoke-sensor-mq-2.jpg)
Flammable Gas & Smoke Sensor MQ-2
free shipping in Poland for all orders over 500 PLN
If your payment will be credited to our account by 11:00
Each consumer can return the purchased goods within 14 days
Flammable Gas & Smoke Sensor MQ-2
This semiconductor gas sensor detects the presence of combustible gas and smoke at concentrations from 300 to 10,000 ppm. The sensor’s simple analog voltage interface requires only one analog input pin from your microcontroller.
![]() |
This flammable gas and smoke sensor detects the concentrations of combustible gas in the air and ouputs its reading as an analog voltage. The sensor can measure concentrations of flammable gas of 300 to 10,000 ppm.The sensor can operate at temperatures from -20 to 50°C and consumes less than 150 mA at 5 V. Please read the MQ2 datasheet (184k pdf) for more information about the sensor.
![]() |
Gas sensor with metal case bottom view. |
---|
Connecting five volts across the heating (H) pins keeps the sensor hot enough to function correctly. Connecting five volts at either the A or B pins causes the sensor to emit an analog voltage on the other pins. A resistive load between the output pins and ground sets the sensitivity of the detector. Please note that the picture in the datasheet for the top configuration is wrong. Both configurations have the same pinout consistent with the bottom configuration.The resistive load should be calibrated for your particular application using the equations in the datasheet, but a good starting value for the resistor is 20 kΩ.
We offer two breakout boards that make it easier to interface with these sensors: a Pololu carrier board and a SparkFun carrier board. The Pololu version is shown below.
|
![]() |
Pololu MQ Gas Sensor Carrier |
![]() |
Carbon Monoxide Gas Sensor MQ-7 |
![]() |
Alcohol Gas Sensor MQ-3 |
Acrylic clear case with fan for Banana Pi M2+. The case needs to be assembled by yourself
No product available!
No product available!
No product available!
No product available!
MMA7341L 3-Axis Accelerometer ą3/11g
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
The light line has 8 LEDs type WS2812 - thanks to the built-in controller, it is possible to connect the strips in series and control them with one signal cable. NeoPixel Stick 8 x WS2812
No product available!
No product available!
No product available!
No product available!
No product available!
The Kamami USB-Blaster is a programmer and configurator for PLD\'s manufactured by Altera. It is fully compatible with USB Blaster, then it can operate with a commercial and evaluation versions of the Altera Quartus project packet
No product available!
Flammable Gas & Smoke Sensor MQ-2