- Out-of-Stock
A small single board computer with a Sitara ™ processor (1 GHz, ARM Cortex-A8), 512 MB DDR3 RAM. It has a built-in 3D accelerator. The board also includes a microSD card slot and a microUSB slot.
A small single board computer with a Sitara ™ processor (1 GHz, ARM Cortex-A8) that has 512 MB of DDR3 RAM. It has a built-in 3D accelerator, 32-bit programmable real-time units (PRUs) with a frequency of 200 MHz. BeagleBone Pocket offers 72 I / O pins, 44 of which can be used as GPIO, many communication interfaces; 3 x UART (2 enabled by default), 2 x I2C, 2 x SPI, 2 x CAN, 8 analogue inputs and 4 PWM signal outputs. The board also includes a microSD card slot and a microUSB slot.
Single board computer with ARM Cortex-A8 AM335x processor, clocked at 1 GHz with 512 MB of RAM. The module has, among others USB interfaces, I / O pins, WiFi and Bluetooth. SeeedStudio 102010048
No product available!
LCD display with controller CS1621 / HT1621 serial protocol, 66x26x5 mm
No product available!
No product available!
The most popular Sn60Pb40 SW26 solder is a high-quality lead product with SW26 flux, intended for professional soldering in electronics and electrical engineering, meeting the EN ISO 9453:2014 standard
No product available!
A development board that offers advanced programming and experimentation capabilities for smart device and industrial automation applications. It is based on the Rockchip RV1103 system, has an NPU unit and an ISP input. It offers a built-in Ethernet port, USB, GPIO and 128 MB of SPI Flash memory. Waveshare Luckfox Pico Plus M
No product available!
Digilent ZYBO SoC platform powered by Xilinx Zynq Z-7010 with a dual-core ARM® Cortex-A9 processor and an Xilinx 7-series FPGA. 410-279
No product available!
No product available!
No product available!
MINIATURE GENERATOR WITH A SETTING FREQUENCY SIGNAL - A KIT FOR INDEPENDENT INSTALLATION
No product available!
No product available!
Probe for measuring direct and alternating current with a current of up to 30 A. Works in the band up to 100 MHz, it can be connected to the oscilloscope through the UPI connector. It does not require an external power supply. Micsig CP1003
No product available!
No product available!
No product available!
USB - CAN converter module. It allows the device to be connected to a computer (USB) or microcontroller (UART) via the CAN bus. USB CAN CONVERTER (UCCB)
No product available!
No product available!
No product available!
A small single board computer with a Sitara ™ processor (1 GHz, ARM Cortex-A8), 512 MB DDR3 RAM. It has a built-in 3D accelerator. The board also includes a microSD card slot and a microUSB slot.