- Out-of-Stock
JR Connector Pack, Male
This pack contains everything that you need to add to the small ones. RC servos - to custom cables. You can use a crimping tool to attach your 22-26 AWG wires. This pack contains enough pins and crimp pins (including 3 spare pins) for 3 male connectors . The crimp pins have gold-flashed male contacts.
This JR connector has a 0.1 "pin spacing and mates with the female JR connectors found on RC servos. connector. This pack contains three female JR housings, three male JR shrouds, and twelve gold-flashed crimp pins, which is enough for three male connectors and three spare pins The crimp pins are designed for 22-26 AWG wires, and we sell a crimping tool that works well with your own custom servo cables or servo extension cables.
To assemble the connectors, push the crimped male pins to the place of the protector (the prongs will protrude out of the connector sockets). If you look inside the shroud, you will see a raised bellow; is this this this cr this cr this this this this this this this this this this this this this this this 的 connector this. If you have done things right, you will hear a snap, and it will lock in place. Note that if you have a JR connector, you can leave the shroud off.
We also sell Futaba J connectors, which are very similar to the premade servo extension and splitter cables.
Note: these connectors are commonly referred to as "female" in the JR connectors below to make sure they are what you want.
|
|
![]() | JR Connector Pack, Female |
![]() | Crimping Tool: 0.1-1.0 mmÂ? Capacity, 16-28 AWG |
![]() | Female Crimp Pins for 0.1 "Housings 100-Pack |
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
No product available!
A set with two IMX219 cameras with a resolution of 8 MP and an expansion module for the Raspberry Pi, which allows you to connect two cameras simultaneously. ArduCAM B0350
No product available!
The assembled and activated module is designed to control differently colored LEDs. AVTMOD02
No product available!
No product available!
No product available!
High quality XF-ABS filament for 3D printer with 1.75 mm diameter. 1 kg of wire is wound on the spool. XF-ABS-175-GRAY
No product available!
No product available!
No product available!
The official power supply for Raspberry Pi with 5.1V output voltage and 2.5A current efficiency. White power supply.
No product available!
No product available!
No product available!
Permanent cylindrical neodymium magnet with a diameter of 5 mm and a height of 2 mm.
No product available!
The evaluation kit is equipped with the Lattice iCE40 HX FPGA chip. The kit is supported by iCEcube2 and Verilog and Lucid languages. SparkFun DEV-16526
No product available!
No product available!
ROSA3D filament made of high-quality PET-G granules. 0.8 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D PET-G Standard Juicy Orange
No product available!
Micro SD 8GB class 4 card with Linux Raspbian Wheezy for RPi
No product available!
JR Connector Pack, Male