- Out-of-Stock
![Pololu 1481 - LPG / Isobutane / Propane Gas Sensor MQ-6 Pololu 1481 - LPG / Isobutane / Propane Gas Sensor MQ-6](https://kamami.pl/8876-large_default/pololu-1481---lpg--isobutane--propane-gas-sensor-mq-6.jpg)
LPG / Isobutane / Propane Gas Sensor MQ-6
free shipping in Poland for all orders over 500 PLN
If your payment will be credited to our account by 11:00
Each consumer can return the purchased goods within 14 days
LPG / Isobutane / Propane Gas Sensor MQ-6
This semiconductor gas sensor detects the presence of LPG, isobutane, and propane at concentrations from 300 to 10,000 ppm. The sensor’s simple analog voltage interface requires only one analog input pin from your microcontroller.
![]() |
This propane gas sensor detects the concentrations of LPG, isobutane, and propane in the air and ouputs its reading as an analog voltage. The sensor can measure concentrations of 300 to 10,000 ppm.The sensor can operate at temperatures from -10 to 50°C and consumes less than 150 mA at 5 V. Please read the MQ6 datasheet (178k pdf) for more information about the sensor.
![]() |
Gas sensor with metal case bottom view. |
---|
Connecting five volts across the heating (H) pins keeps the sensor hot enough to function correctly. Connecting five volts at either the A or B pins causes the sensor to emit an analog voltage on the other pins. A resistive load between the output pins and ground sets the sensitivity of the detector. Please note that the picture in the datasheet for the top configuration is wrong. Both configurations have the same pinout consistent with the bottom configuration.The resistive load should be calibrated for your particular application using the equations in the datasheet, but a good starting value for the resistor is 20 kΩ.
We offer two breakout boards that make it easier to interface with these sensors: a Pololu carrier board and a SparkFun carrier board. The Pololu version is shown below.
|
![]() |
Pololu MQ Gas Sensor Carrier |
![]() |
Flammable Gas & Smoke Sensor MQ-2 |
![]() |
Carbon Monoxide Gas Sensor MQ-7 |
No product available!
No product available!
No product available!
AVT kit for self-assembly of 6V gel battery protection. AVT1970 B
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
NanoPi Duo is a small PCB equipped with the SoC Allwinner H2+ system, RAM memory with a capacity of 256 MB and a built-in Wi-Fi module. The GPIO port has been moved, among others Ethernet, USB, SPI, UART, I2C interface. The set is perfect for light IoT applications
No product available!
DIGITAL MAGNETOPHONE WITH ISD17180 SYSTEM - A KIT FOR INDEPENDENT INSTALLATION
No product available!
ROSA3D filament made of high-quality PLA granules. 0.8 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D PLA Starter Dark Blue
No product available!
A module with Acconeer sensor A111. A111 is a one-chip radar (PCR) solution complete with antennas and SPI interface up to 50 MHz. SparkFun Pulsed Radar Breakout A111
No product available!
LPG / Isobutane / Propane Gas Sensor MQ-6