- Out-of-Stock
Flora Lux Sensor - TSL2561 Light Sensor - v1.0
ID: 203914
TSL2561 luminosity sensor is an advanced digital light sensor, ideal for use in a wide range of light situations. Adafruit 1246
DESCRIPTION
Add light-reactive sensing to your wearable Flora project with this high precision Lux sensor. The TSL2561 luminosity sensor is an advanced digital light sensor, ideal for use in a wide range of light situations. Compared to low cost CdS cells, this sensor is more precise, allowing for exact lux calculations and can be configured for different gain/timing ranges to detect light ranges from up to 0.1 - 40,000+ Lux on the fly. The best part of this sensor is that it contains both infrared and full spectrum diodes! That means you can separately measure infrared, full-spectrum or human-visible light. Most sensors can only detect one or the other, which does not accurately represent what human eyes see (since we cannot perceive the IR light that is detected by most photo diodes)
The sensor has a digital (I2C) interface. Attaching it to the flora is simple: line up the sensor so its adjacent to the SDA/SCL pins and sew conductive thread from the 3V, SDA, SCL and GND pins. They line up perfectly so you will not have any crossed lines. You can only connect one lux sensor to your Flora, but you can connect other I2C sensors/outputs by using the set of SCL/SDA pins on the opposite side. The current draw is extremely low, about 0.5mA when actively sensing, and less than 15 uA when in powerdown mode.
TECHNICAL DETAILS
- RoHS
- 0.55"/14mm diameter, 0.07"/1.8mm thick
- Approximates Human eye Response
- Precisely Measures Illuminance in Diverse Lighting Conditions
- Temperature range: -30 to 80 *C
- Dynamic range (Lux): 0.1 to 40,000 Lux
- Voltage range: 2.7-3.6V
- This board/chip uses I2C 7-bit addresses 0x39, 0x29, 0x49, selectable with jumpers.
PRODUCT ID: 1246
203914
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Other products in the same category (16)
Camera with a resolution of 1 MPx with a USB interface. Equipped with a GC1024 CMOS sensor with a 68° angle of view lens. ArduCAM U6061
Retired
No product available!
Camera with a monochrome CMOS OV9281 sensor with a resolution of 1280x800 px. Equipped with a snapshot, it communicates via the 2-lane MIPI interface. ArduCAM U6072
Retired
No product available!
Camera with OV9655 CMOS sensor with a resolution of 1289x1024 px. It communicates via a parallel interface. ArduCAM U6040
Retired
No product available!
Camera with CMOS NT99141 sensor with a resolution of 1288x728 px. It communicates via a parallel interface. ArduCAM U6044
Retired
No product available!
Camera with OV9712 CMOS sensor with a resolution of 1280x720 px. It communicates via the DVP parallel interface. ArduCAM U6041
Retired
No product available!
Camera with OV7725 CMOS sensor with a resolution of 640x480px. It communicates via a parallel interface. ArduCAM U6038
Retired
No product available!
Camera with OV7675 CMOS sensor with a resolution of 640x480 px. It communicates via a parallel interface. ArduCAM U6037
Retired
No product available!
Camera with OV2710 CMOS sensor with a resolution of 1945x1109 px. It communicates via a parallel interface. ArduCAM U6034
Retired
No product available!
Camera with CMOS AR0330 sensor with a resolution of 2304x1286 px. It communicates via a parallel interface. ArduCAM U6032
Retired
No product available!
Camera in the form of a SoC chip with a CMOS MT9P111 sensor with a resolution of 2592x1944 px. It communicates via a parallel interface or MIPI. ArduCAM U3470
Retired
No product available!
Camera with OV2640 CMOS sensor with a resolution of 1600x1200 px. It communicates via the SCCB parallel interface. ArduCAM U0061
Retired
No product available!
Camera with CMOS MT9M112 sensor with a resolution of 1280x1024 pixels. It communicates via the DVP parallel interface. ArduCAM U6080
Retired
No product available!
Adapter dedicated to Omnivision cameras. Allows you to connect an image sensor to the evaluation kit. ArduCAM B0012
Retired
No product available!
Camera module 18 Mpx with AR1820HS sensor working with Raspberry Pi. It offers a video resolution of up to 4912x3684 pixels at 15 fps. ArduCAM B0164
Retired
No product available!
Camera module based on the OV13850 CMOS matrix with a resolution of 4224x3136 px (13 MPx). Designed for use with ArduCAM USB Shield. ArduCAM B0129
Retired
No product available!
ArduCAM OV9281 1MP Global Shutter USB Camera Evaluation Kit - Evaluation Kit with 1MP OV9281 166°...
A set with a camera with a resolution of 1 MPx with an OV9281 sensor, a USB 3.0 adapter and a cable. ArduCAM EK024
Retired
No product available!
TSL2561 luminosity sensor is an advanced digital light sensor, ideal for use in a wide range of light situations. Adafruit 1246