- Out-of-Stock
OP4EB-AdeunisWMBUS
ID: 207609
Hardware extension adds Wireless M-BUS radio communication capability to Open4, EvoPrimer and STM32 Primer2 platforms
Adeunis Wireless M-BUS Extension is a hardware/firmware extension pack designed to add additional WM-BUS (868 MHz) radio frequency evaluation features to the Open4 primers, EvoPrimer or STM32 Primer2 evaluation and development platforms.
By adding Adeunis Wireless M-BUS Extension board and Adeunis firmware application users can immediately evaluate and test WM-BUS communications. Specific test modes include:
- Standard mode for operation as a meter or gateway
- Sniffer mode to scan a perimeter and receive indexes from all meters in range
- TX/RX mode for conventional send/receive operation
Adeunis firmware is based on CircleOS and functions directly on STM32F103VG and STM32F103VE equipped Open4, EvoPrimer and STM32 Primer2 platforms.
The extension pack includes:
- One extension board with Adeunis WM-BUS module
- One antenna
- User's guide
Adeunis Downloads & Doc for this product:
- Firmware - ARF_SK_OPEN4_FIRMWARE_UPDATE
- User guide - ARF_WIRELESS_M-BUS_SK_OPEN4_USER_GUIDE
207609
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Other products in the same category (16)
No product available!
No product available!
No product available!
Banana Pi R2 is a mini-computer (router) equipped with a Quad-core ARM Cortex-A7 quad-core MediaTek MT7623N processor, 2 GB of RAM, WiFi module, Bluetooth 4.1 and connectors: HDMI, 5 x Ethernet, 2x USB 3.0. The set has a 40-pin GPIO connector, on which you can find UART, SPI, I2C and ID EEPROM interfaces.
Retired
No product available!
USB A 2.0 / USB C cable silicone, 1 m, black
Retired
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
The power supply module with the RTC DS3231SN clock is designed for the Raspberry Pi. It allows you to power minicomputer with voltage up to 28 V and create scripts for the power-on sequence. Pimoroni WITTY_PI_3_R2
Retired
No product available!
No product available!
No product available!
No product available!
No product available!
Module with a UV ultraviolet light sensor VEML6075. It enables measurement of the level of UVA (350-375 nm) and UVB (315-340 nm) radiation. It communicates via the I2C bus. Pimoroni PIM460
Retired
No product available!
Hardware extension adds Wireless M-BUS radio communication capability to Open4, EvoPrimer and STM32 Primer2 platforms