- Out-of-Stock
ELF-VLF MULTIODORNIK ELEMENT - RECEIVER CO-OPERATING WITH MAGNETIC ANTENNA AND- PRINTED PLATE
Producer: AVT
The ELF-VLF receiver, or rather a set of receivers, enables reception of mysterious radio signals with extremely low frequencies. It is possible to observe signals of communication with submarines and so-called Schumann resonance.
It is possible only in extra-urban conditions (eg during trips), and this is due to the high level of industrial disturbance in cities. In the city, the described systems can be used, for example, to observe storms and the level of industrial disturbances. Such their use can also be very interesting. A lot of information about the reception of electromagnetic waves at very low frequencies, below 30kHz, as well as about antennas used for this type of receivers, is provided in the article 'Receiving ELF-VLF radio waves'.
The project presents four receivers, designed to receive radio signals (electromagnetic waves) in the range from 3Hz to 30kHz, thus including bands: ELF, SLF, ULF and VLF. The first of the receivers (I) cooperates with a wire antenna, reacting to the electrical component of the electromagnetic field. It was made in two system versions (Ia and Ib). The third and fourth are designed to cooperate with a loop antenna, reacting to the magnetic component of the electromagnetic field. The article also describes the system generating symmetrical power supply voltage and systems improving work comfort by increasing resistance to unwanted signals: two low-pass filters with band respectively 200Hz and 20kHz, bandpass filter, reducing the hum of 50Hz and optoisolator m signals .cz. The described systems do not require tuning or startup, so that even a novice electronics can do it. The big advantage of these systems is the low cost of their implementation.
Note: the project has been divided into 6 parts:
AVT3054 / 2
The amplifier cooperating with the magnetic antenna must be characterized by low input impedance and the lowest possible level of own noise. Such a system can be implemented using, for example, a low noise amplifier with an OPA1632 differential input.
Includes AVT3054 / 2 printed circuit board and documentation.
Detailed description in EdW3 / 13 or ![]()
Additional materials:
Article 'ELF-VLF radio reception' from the journal Elektronika Dla Wszystkich 10/2011
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Cable with USB type A and lightning connectors, cable length 1.8m. Lanberg CA-USLM-
No product available!
Cable with USB type A and lightning connectors, cable length 1.8m. Lanberg CA-USLM-
No product available!
Cable with USB type A and lightning connectors, cable length 3m. Lanberg CA-USLM-10CU-0030-WH
No product available!
Cable with USB type A and lightning connectors, cable length 3m. Lanberg CA-USLM-10CU-0030-BK
No product available!
Li-Ion 18650 battery with a nominal voltage of 3.6V and a capacity of 3000mAh. It has protection against overcharging, excessive discharge, overload and short circuit.
No product available!
Processor charger designed for Li-Ion cylindrical batteries in various sizes (including 18650). It can charge batteries both with PCM protection and without protection. The nominal charging current in the main phase is 1A. XTAR MC1S
No product available!
Container for two 18650 batteries. It allows you to safely transport batteries and ensure their proper storage
No product available!
Expansion board equipped with VL6180 distance sensor, based on FlightSense technology. The set is designed to measure distances and detect gestures. X-NUCLEO-6180A1
No product available!
An extension module to support two cameras designed for Raspberry Pi minicomputers. The board allows you to connect two cameras via CSI connectors to one connector of the minicomputer. ArduCAM B0195
No product available!
Scale module with aluminum tensometer beam, allowing weight measurement up to 2 kilograms. It has screw terminals. Can be used to make electronic scale. KAmodTENSOMETER2kg
No product available!
4x16 display with LED backlight negative blue. Equipped with HD44780 compatible controller. Artronic LCD-EC-1604A-BIW W/B-E6 C
No product available!
Development kit based on MediaTek MT7622 chip with 64-bit ARM Cortex-A53 dual-core processor. It is equipped with 1GB SDRAM, 8GB eMMC memory and numerous connectors and interfaces such as SATA, Ethernet, microSD socket and USB 3.0 Host. The kit creates a router that can run on various open source operating systems, including OpenWrt and Linux. Banana Pi BPI-R64
No product available!
The DDS generator with alphanumeric display allows you to generate sine, rectangular or triangle waveforms with a frequency of up to 5MHz. The device can also be used to measure frequencies in the 1Hz-60MHz range.
No product available!
Wireless mouse with a precise optical sensor. It has a button to change the resolution in three levels: 800/1200/1600 DPI. The set is equipped with a USB adapter, mouse range up to 10 m. Natec NMY-1189
No product available!
3.5" LCD display with touch screen, 480x320 pixel resolution. Controlled via SPI interface. ArduCAM U6111
No product available!
CR2016 lithium battery with 3V voltage and 90mAh capacity. Maxell CR2016
No product available!
ELF-VLF MULTIODORNIK ELEMENT - RECEIVER COOPERATING WITH MAGNETIC ANTENNA AND- PRINTED PLATE