MYS-SAM9G35 SBC board

The AM receiver of the DCF77 signal with the MAS6180 system, allows to receive the frames of the synchronization signal from the time standard, using the carrier frequency of 77.5kHz. Thanks to this module, it is possible to create a clock with automatic date and time synchronization. The module has a ferrite antenna. modDCF77

MODERN LIGHTING CABIN - PRINTED PLATE

Dragino LoRa Shield is an expansion board for Arduino (Uno, Leonardo, Mega, DUE) with a LoRa communication module (RFM98W system). Works at 433 MHz, maximum power up to 100 mW. In the set with the plate there is also an antenna. Seeed studio 113990194

ROB-12697

Micro SD 16GB class 10 card with Linux Raspberry Pi OS for RPi (old Raspbian)

PCB board and programmed system for thermometer with LED display. AVT3122 A +

Camera module 8 MPx with IMX219 sensor and lens with a viewing angle of 75°. To be used as a replacement on the RPI Camera Board V2. ArduCAM B0188

Carbon fiber propeller CW and CCW 9x4.7 SF (1 pair) (HK39772)

Shield for MAXimator set, 4-digit 7-segment LED display, 2 RGB type WS2812B diodes, STLM20 temperature sensor, two buttons

LCD 4x20, 98x60mm, LED backlight (WHITE) NEGATIVE BLUE, STN, enhanced temperature range, 2-LED.

Angular socket JST XH cable-plate, male, 2 pins, pitch 2,5mm, THT, 250V, 3A, ROHS

PCB board ICSP programmer for PIC microcontrollers

DEV-10182 - Monster Moto Shield

ELECTRICITY METER AND WATOMIER - PRINTED PLUG AND PROGRAMMED SYSTEM

Development kit chipKIT DP32 equipped with PIC32MX250F128B microcontroller (40/50 Mhz, 128 kB Flash, 32 kB RAM), prototype area with solder pads, potentiometer, 4 LED diodes, 2 buttons and soldering pads for EEPROM memory and analog temperature sensor. Digilent 410-280P-KIT