Micro Pololu motor bracket 2 pcs.

The Arduino 9 Axes Motion Shield allows your Arduino to measure movement: orientation, acceleration and magnetic field. A000070

Plastic holder that could fit all the boards with Arduino UNO size (68,6 mm x 53,4 mm). Contains 5 pieces in different colours. A000018

CryptoShield is a dedicated security peripheral for the Arduino. This shield adds specialized ICs that perform various cryptographic operations which will allow you to add a hardware security layer to your Arduino project. It also is a nice device for those performing embedded security research. DEV-13183

Banana Pi G1 Open Debugger Board Burner Module

Banana Pi R1 acrylic clear case. The case needs to be assembled by yourself

The housing for the Banner PI G1 Debugger made of transparent plastic. Housing for self-assembly

The I2C electric level conversion module is specifically designed for Banana Pi. The module converts the 3.3V of I2C electric level to 5V level or converts 5V to 3.3V

BPI AD/DA extend module with the PCF8591 single-chip, single-supply low-power 8-bit CMOS data acquisition device with four analog inputs, one analog output and a serial I2C-bus interface

Antena 3 DB do Banana Pi R1

5dB antenna for the Banana Pi R1 router in the version with 300Mps wifi and five LAN 100/1000 ports.

STM32F103 programming cable for Open Debugger Burn Board and Banana Pi G1 connection

CC3200 programming cable for Open Debugger Burn Board and Banana Pi G1 connection

CC2530 and CC2540 programming cable for Open Debugger Burn Board and Banana Pi G1 connection

It is a standard audio-video cable, which can be successfully used to connect Banana Pi M1 or Raspberry Pi 1 model B and A. Cable length is 98 cm, has two ends of the chinch type.