ST7FLITE10F1M6

NanoPi NEO is a miniature board with the all-in-one SoC Allwinner H3 chip (ARM Cortex-A7) with built-in Ethernet communication. Works with Ubuntu MATE, Debian, etc. It can be powered by the microUSB port. The board also contains a USB port, a serial port and a 36-pin GPIO connector

HK TL-242 Thread Locker & Sealant Medium Strength (10959)

Krzysztof Wesołowski

LOOP MODULE FOR RAILWAY MAKEUP - PLATE AND PROGRAMMED LAYOUT

LITTLE LAMP AMP AUTOMATIC - PLATE AND PROGRAMMED LAYOUT

Printed circuit board for the modular listening receiver for the 80m and 40m Dosia bands. AVT3192 A

CryptoShield is a dedicated security peripheral for the Arduino. This shield adds specialized ICs that perform various cryptographic operations which will allow you to add a hardware security layer to your Arduino project. It also is a nice device for those performing embedded security research. DEV-13183

IMPULSE COUNT VERSION 27mm - SELF-ASSEMBLY KIT

Waveshare aluminum radiator for CPU Raspberry Pi B +, Raspberry Pi 2 and Raspberry Pi 3. Radiator has self-adhesive tape

Male terminal block, angled, 3-pin. Pitch 5.0mm. Height 7.8mm. 2EDGRC-5.0-3P

THE SMALLEST MILLIOLOMETER MODULE FOR POWER SUPPLY - SET ASSEMBLED AND STARTED

Module with a differential I2C transceiver allowing to extend the range of the I2C communication bus. The differential signals are sent over an Ethernet cable that plugs into the RJ-45 connector. SparkFun BOB-14589