THT 1.7R 5% 1 / 4W carbon resistor

Assembled, remote controlled 4-channel switch. AVT5599 C

Motion MEMS and environmental sensor expansion board for STM32 Nucleo, equipped with Arduino UNO R3 connector layout; designed around the LSM6DSL 3D accelerometer and 3D gyroscope, the LSM303AGR 3D accelerometer and 3D magnetometer, the HTS221 humidity and temperature sensor and the LPS22HB pressure sensor. The board interfaces with the STM32 microcontroller via the I²C pin

EP02 / 16

PANEL MULTIMETER - HIDDENED AND LAUNCHED SYSTEM

LED THERMOMETER - 7mm VERSION - THE SYSTEM HOLDED AND STARTED

The light line has 8 LEDs type WS2812 - thanks to the built-in controller, it is possible to connect the strips in series and control them with one signal cable. NeoPixel Stick 8 x WS2812

Extension for Raspberry Pi; communication module with RS-485 interface (DEV-13000). Module with the possibility of mounting the DB-9 socket, the socket should be purchased separately

Universal expansion shield for prototyping in accordance with Raspberry Pi 2/3 Model B + with screw connections and goldpin type of sockets

Raspberry Pi 2 and Pi 1 model B+ Enclosure - Clear

BPI AD/DA extend module with the PCF8591 single-chip, single-supply low-power 8-bit CMOS data acquisition device with four analog inputs, one analog output and a serial I2C-bus interface

The eXtremestyle silicone cable (1.5m length) with Lightning connector. Allows you to charge the device and transfer data. eXtreme S15ULB