- Out-of-Stock
Kamami USB-Blaster - USB programmer for Altera PLD's
ID: 560286
The Kamami USB-Blaster is a programmer and configurator for PLD's manufactured by Altera. It is fully compatible with USB Blaster, then it can operate with a commercial and evaluation versions of the Altera Quartus project packet
Free shipping
free shipping in Poland for all orders over 500 PLN
Same day shipping
If your payment will be credited to our account by 11:00
14 days for return
Each consumer can return the purchased goods within 14 days
Description
The Kamami USB-Blaster is a programmer and configurator for PLD's manufactured by Altera. It is fully compatible with USB Blaster, then it can operate with a commercial and evaluation versions of the Altera Quartus project packet.
The programmer is a functional equalivent to the USB Blaster interface manufactured by Altera. Using this, You can in-system program CPLD's and configurator's Flashes (with ISP interface). Also, it can configure FPGA devices. The programmer uses a USB port.
Features
- Can configure and program every CPLD, FPGA and memories-configurators made by Altera
- Standard connector IDC10, compatible with Altera recomendations
- Logic levels on the output connector are compatible with TTL-LV, TTL, CMOS5, CMOS33.
- Powered from USB port (microUSB connector)
Software
Software for the USB Blaster programmer can be downloaded from here: https://www.altera.com/support/software/download/sof-download_center.html.
Included
- Programmer
- USB A/B-micro cable
- Ten conductors IDC10 cable (lenght: 0.3m/11.8inch)
560286
You might also like
Available
USB Blaster Download Cable
zł418.85
24h
Available quantity: 13
Available
JTAG interface galvanic separator that protects equipment against damage caused by potential differences, with a maximum clock frequency of 110 MHz, 3-5 V power supply, and isolation voltage up to 1 kVDC, equipped with multiple connectors and optical status signaling
zł399.00
24h
Available quantity: 47
Available
Easy-to-use retractable cable with USB type A plugs and micro-B type, the cable has a length of 73 cm
zł5.03
24h
Available quantity: 226
Available
Programmer-configurator PLD (CPLD and FPGA) from Altera, compatible with Altera USB Blaster Download Cable. It supports Altera JTAG and ISP/ICP interfaces.
zł137.96
24h
Available quantity: 123
Available
Other products in the same category (16)
No product available!
No product available!
Toulson and Wilmshurst
Delivery date unknown
No product available!
AVT set for a stand-alone executive module with triac. AVT1965 B
Retired
No product available!
Development board with SAMD21 microcontroller (ARM Cortex® M0+), 8 I/O lines, 12 PWM channels, micro-USB. The board is equipped with the ATSAMD21 module and SARA-U201 U-blox enabling the implementation of communication in GSM networks. Arduino MKR GSM 1400 ABX00018
Retired
No product available!
Printed circuit board with programmed night lamp controller system with time system. AVT1969 A +
Retired
No product available!
No product available!
No product available!
MEMS and environmental sensor expansion board for STM32 Nucleo
Delivery date unknown
No product available!
EVALUATION BOARD AND MIDIUS MUSIC KEYPAD - PRINTED PLATES AND PROGRAMMED SYSTEM - PLATE AND PROGRAMMED LAYOUT
Retired
No product available!
No product available!
The board with the microcontroller STM32F405RGT6 in the set with the base board and expansion modules. Waveshare Open405R-C Package B
Retired
No product available!
No product available!
No product available!
No product available!
Antenna with built-in LNA amplifier with high sensitivity, for mounting in a device using a GPS module. The antenna has a 25mm cable, terminated with a U.FL plug (IPEX). Dimensions of the device: 9 x 9 x 4mm
Retired
No product available!
The Kamami USB-Blaster is a programmer and configurator for PLD's manufactured by Altera. It is fully compatible with USB Blaster, then it can operate with a commercial and evaluation versions of the Altera Quartus project packet