- Out-of-Stock
AVT5455 / 2 C - remote two channel receiver RECEIVER. Assembled set
ID: 562080
Assembled two-channel remote control receiver. AVT5455 / 2 C
Description
Radio system that allows remote switching of two 230V / 5A electricity receivers. The relays can work in bistable or pulse mode, which allows you to control the drive of the entrance gate or garage door.
Project AVT 5455 EP 06/14
properties
- Radio control in the 433 MHz band
- 2 relay outputs with a load capacity of: 230VAC / 5A
- Range around 30m
- Bistable operation (on / off) or monostable (impulse)
- Remote control: battery LR23 12V
- Receiver power supply: 9 ... 12VAC or 9 ... 15VDC, maximum current consumption 120mA
- Board dimensions: 85x29mm
Included
- Assembled receiver
562080
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
AVT kit for self-assembly gigatermometer. AVT3155 B
Retired
No product available!
No product available!
PCB and programmed circuit for nixie clock with seconds. AVT3141 A +
Delivery date unknown
No product available!
PCB and programmed circuit for the GSM controller. AVT5555 A +
Delivery date unknown
No product available!
AVT kit for self-assembly of the GSM controller. AVT5555 B
Retired
No product available!
No product available!
Transparent housing for Orange Pi Plus 2e, folded into snaps, made of plastic. It protects and protects your computer against dust and mechanical damage
Retired
No product available!
No product available!
No product available!
No product available!
Assembled 4-channel dimmer for network lighting. AVT5361 C
Retired
No product available!
No product available!
Double transparent housing for Raspberry computers: Pi 3 model B +, Pi 3 model B, Pi 2 model B and Pi 1 model B + allows you to place two Raspberry Pi computers. Mounted on screws without the use of glue, made of plastic
Retired
No product available!
Bluetooth module with integrated HC-08 system. Thanks to the angular pin connector with the bus signals, it is possible to easily connect the module to the contact plate or wires
Retired
No product available!
Arduino-powered, electromyography (EMG) sensor kit that provides you with a MyoWare Muscle Sensor, each shield developed here at SparkFun, and everything you need to connect them all together. KIT-13772
Retired
No product available!
Assembled automatic power switch for car installation. AVT1877 C
Retired
No product available!
Assembled two-channel remote control receiver. AVT5455 / 2 C