- Out-of-Stock
DCF77 signal receiver (MAS6180) with a ferrite antenna
ID: 562522
The AM receiver of the DCF77 signal with the MAS6180 system, allows to receive the frames of the synchronization signal from the time standard, using the carrier frequency of 77.5kHz. Thanks to this module, it is possible to create a clock with automatic date and time synchronization. The module has a ferrite antenna. modDCF77
Description
The AM receiver of the DCF77 signal with the MAS6180 system, allows to receive the frames of the synchronization signal from the time standard, using the carrier frequency of 77.5kHz. Thanks to this module, it is possible to create a clock with automatic date and time synchronization. The module has a ferrite antenna.
properties
- DCF77 signal receiver with MAS6180B5 system
- It allows you to synchronize clocks with the cesium time pattern
- Power supply: 1.1V - 3.6V
- Signals led out to soldering pads (6 pads)
- Description of pins:
- V - positive supply pole
- G - negative power pole
- TN - DCF77 signal output
- AO - positive supply pole
- PO - sleep mode (high state) or work (low state)
- F - not used
- Module dimensions: 26mm x 14mm x 3mm
Included
- Receiver module DCF77 with a ferrite antenna
562522
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Other products in the same category (16)
The break-out board for the Arduino 101 LGA module. Just like the YUN, it integrates an ATmega32U4 and an Atheros AR9331 with WiFi and Linino OS. A000126
Retired
No product available!
Assembled executive module with triac. AVT1965 C
Retired
No product available!
No product available!
Tape, in the form of a braid, to remove the excess of molten solder brazing material during soldering and desoldering of electronic components 1.5m
Retired
No product available!
No product available!
Garr M. Jones, PE, DEE, Robert L. Sanks, PhD, PE, George Tchobanoglous, Bayard E. Bosserman, II
Delivery date unknown
No product available!
No product available!
No product available!
No product available!
Decoder for receiving digital terrestrial TV programs in the DVB-T2 H.265 standard. Equipped with HDMI, SCART, RF, USB and RJ45 connectors
Retired
No product available!
MYIR MYS-7Z0007S-C is a single board module based on the Xilinx XC7Z007S-1CLG400C chip (Zynq-7007S). This system consists of a single-core processor based on Cortex-A9 core, which can operate at a maximum frequency of 667 MHz and Artix-7 FPGA. The computer is equipped with 512 MB of DDR3 SDRAM, 4 GB of eMMC memory and 16 MB of QSPI Flash memory
Retired
No product available!
47:1 Metal Gearmotor 25Dx52L mm HP with 48 CPR Encoder
Retired
No product available!
No product available!
Case for the Raspberry PI 2 model B, Raspberry PI 1 model B+ and Raspberry PI 3 computers, manufactured from high quality acrylic. CLEAR
Retired
No product available!
No product available!
Arduino ADK is a board in the ATmega2560 microcontroller and a USB interface that allows communication with Android smatrfones. The board provides, among others: 54 I / O lines, 14 PWM channels, 4 UART interfaces. A000069
Retired
No product available!
The AM receiver of the DCF77 signal with the MAS6180 system, allows to receive the frames of the synchronization signal from the time standard, using the carrier frequency of 77.5kHz. Thanks to this module, it is possible to create a clock with automatic date and time synchronization. The module has a ferrite antenna. modDCF77