- Out-of-Stock
Pocket VNA - vector network analyzer
ID: 563215
Vector network analyzer with two ports. It can perform measurements at frequencies from 500 kHz to 4 GHz. Connected to a computer via USB. Pocket VNA
Description
2-port vector network analyzer that can measure from 500kHz to 4GHz. It offers a dynamic range of up to 80 dB at frequencies up to 350 MHz and up to 40 dB at 4 GHz. It allows you to determine all S-parameters (S11, S21, S12, S22), amplitude, phase parameters and group delays of 2-port devices used in networks, as well as quickly and error-free determination of faults in coaxial cables. It can also be used as a simple signal generator. It will be used for analyzing antennas, measuring cable length and tuning filters.
Features
- 2-port vector network analyzer
- Fully bi-directional (S11, S21, S12, S22)
- Linear and logarithmic scanning
- Frequency range: 500 kHz to 4 GHz
- Typical dynamic range: for 350 MHz to 70 dB, for 4 GHz to 40 dB
- Impedance range: 3 to 1000 Ω
- The output power, -14 dBm at 100 MHz, varies with frequency
- Measurement rate: 10 ms per step plus communication
- Number of steps: from 1 to 10001
- Resolution of frequency setting 1 Hz
Kit contains
- PocketVNA
- USB cable
563215
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
No product available!
Compact, 4-channel logic analyzer with a sampling frequency of 100 MHz with a 2.8 "LCD display. It is used to analyze the logic relationships of digital systems. Seeed Studio 109990365
zł540.36
24h
Available quantity: 1
Available
Lan tester can easily read the correct pin configuration of 10Base-T cable, 10Base-2 cable, RJ45/RJ11 modular cables, 258A, TIA-568A/568B and Token Ring cable etc. by comparing one transmitting end to the corresponding receiving end. z28586
zł66.42
24h
Available quantity: 2
Available
Other products in the same category (16)
Antenna with built-in LNA amplifier with high sensitivity, for mounting in a device using a GPS module. The antenna has a 25mm cable, terminated with a U.FL plug (IPEX). Dimensions of the device: 9 x 9 x 4mm
Retired
No product available!
The GY-GPS6MV1 module is a board containing the U-blox NEO-6M GPS receiver system. The tile also includes RTC backup battery, antenna connector (U.FL), voltage stabilizer and UART signal outputs
Retired
No product available!
Kit: MAXimator, MAXimator Expander, ZL32PRG - USB Blaster PRO
Retired
No product available!
Power Supply 2.5A 5.1V for Raspberry Pi 3 model B - STONTRONICS T5875DV
Retired
No product available!
MYD-JA5D44 Development Board is a complete educational platform. Its heart is the MYIR MYC-JA5D44 module, which was equipped with the Atmel SAMA5D44 processor based on Cortex-A5 cores. The processor can work at a maximum frequency of 600 MHz. Min. RS232, RS485 connectors, HDMI connector, 3.5 mm Jack Audio inputs, microSD memory card slot, 10/100 Mbps Ethernet slot and many more.
Retired
No product available!
The Raspberry Pi GPIO Triple Expansion Board converts the single GPIO headers on your Raspberry Pi into three parts. DFR0385
Retired
No product available!
Flex Cable for Raspberry Pi Camera - 300mm / 12". Adafruit 1648
Retired
No product available!
Comes with a 6"x6" (152mm x 152mm) square of Pyralux. It\'s ED-Y type copper at 35um (1 oz/ft2) and has a polymide of 25um (1 mil). The thick copper layer means it can carry a lot of current, and its trivial to solder to it. Adafruit 1894
Retired
No product available!
Patchcord UTP 5E Ethernet cable with a length of 50 cm - gray, with 2xRJ45 connectors
Retired
No product available!
Patchcord UTP 5E Ethernet cable with a length of 50 cm - blue, with 2xRJ45 connectors
Retired
No product available!
Patchcord UTP 5E Ethernet cable with a length of 1.5 m - black, with 2xRJ45 connectors
Retired
No product available!
Patchcord UTP 5E Ethernet cable with a length of 3 m - black, with 2xRJ45 connectors
Retired
No product available!
Patchcord UTP 5E Ethernet cable with a length of 5 m - blue, with 2xRJ45 connectors
Retired
No product available!
Patchcord UTP 5E Ethernet cable with a length of 5 m - gray, with 2xRJ45 connectors
Retired
No product available!
The board gives the possibility to significantly extend the functionality of the STM32F407G-DISC1 development kit. The plate contains, among others memory card slot (microSD), Ethernet socket and connectors that can be used to attach SMT32F4DIS modules to the board
Delivery date unknown
No product available!
Camera board for the STM32F407G-DISC1 set. It allows you to capture an image with a resolution of 1280 x 1024 pixels (1.3MP). The set includes a flexible cable that allows the camera to be connected to the STM32F4DIS-BB expansion board
Retired
No product available!
Vector network analyzer with two ports. It can perform measurements at frequencies from 500 kHz to 4 GHz. Connected to a computer via USB. Pocket VNA