Tripod mount for oCam camera

A tachometer is a device designed to measure the rotational speed of various parts in engines and other mechanisms. It calculates revolutions per minute (RPM). The tachometer also measures and monitors load limits, in order to decrease or increase RPM so that the engine or mechanism runs within its optimal parameters. UGears 70153

TLOGGER - ROOM TEMPERATURE RECORDER ON THE SD CARD - SELF-ASSEMBLY KIT

20x2 Character OLED Display, 116x37, Negative Black Surface, Yellow Dot, 5V, RoHS

Thermopile IR Sensor, -20C to +100C, TO-46-4, Amphenol Advanced Sensors, RoHS

Module with GPS receiver (SIM28). The system allows you to track up to 22 satellites. The UART interface is used for communication with the system. The module has a connector in accordance with the Grove standard. Seeed Studio 113020003

SUPERLUMISATION MODULE 3x3LED GREEN 20mA LED - KIT FOR INDEPENDENT INSTALLATION

The Raspberry Pi 3 programming set, contains 205 electronic components, allows you to create many projects and program peripherals. ArduCAM KB0064

GateBox allows you to open and close the gates, and what’s more, to check their status by using a smartphone or tablet, without the need of purchasing an additional equipment or paying hidden fees

MYIR MYC-C7Z020 is a single board computer module based on the MYC-C7Z020 chip. This system consists of a dual-core processor based on the Cortex-A9 core (667 MHz) and the Artix-7 FPGA chip. The board has 1 GB of DDR3 SDRAM, 4 GB of eMMC memory and 32 MB of QSPI Flash memory. The board is equipped with numerous peripherals, the outputs of which have been led out on two 140-pin connectors.

Miniature starter board in the form of a USB plug compatible with Arduino (1.6.5 and newer), based on the ATtiny85 microcontroller. Up to 6 GPIO lines, up to 3 PWM lines, up to 4 ADC lines, SPI or I2C interface, and LED diode