- Out-of-Stock
AVT5638 C - a miniature reminder. Assembled set
ID: 572369
Assembled miniature reminder. AVT5638 C
Description
This small device has been designed, above all, for diabetic care, but you can find a much wider range of applications for it. Its task is to signal the passage of a previously set time interval, measured from pressing a button. In this way, it is possible to remind about the need to measure the level of glucose in the blood after some time from the meal, or to look into the boiler room after some time from firing in the oven.
Project AVT 5638 EP 08/18
properties
- Power from a 3V lithium battery
- Power consumption: in standby mode 0.5 mA, in the active state 8 mA, in the alarm state 7 mA
- Measuring one of 4 predefined times: 15 minutes, 30 minutes, 1 hour, 2 hours
- Timing triggered by the button
- Time set by the DIP-SWITCH switch
- ATtiny12A microcontroller, software in C language
Included
- Assembled reminder
572369
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
WiFi module dedicated to Coral Dev Board Micro. It uses the Murata LBEE5HY1MW chip and connects to the base board via B2B connectors. Coral G650-07974-01
Retired
No product available!
No product available!
Pololu 42x19mm Idler Wheel/Sprocket Pair - Black
Retired
No product available!
No product available!
USB A 2.0 / USB C cable silicone, 1 m, black
Retired
No product available!
Miniature (22x13.5x6mm) WiFi module b / g / n with TCP and UDP protocols operating in standalone and access point modes. 2.0mm goldpin connector. The module is equipped with a UART interface, it is also possible to control GPIO lines (also as PWM). Powered by 3.3V. Antenna: copper wire
Retired
No product available!
A development board that offers advanced programming and experimentation capabilities for smart device and industrial automation applications. It is based on the Rockchip RV1103 system, has an NPU unit and an ISP input. It offers a built-in Ethernet port, USB, GPIO and 128 MB of SPI Flash memory. Waveshare Luckfox Pico Plus
Retired
No product available!
PCB and programmed layout for a 3-axis CNC generator. AVT5422 A +
Retired
No product available!
No product available!
No product available!
High quality XF-ABS filament for 3D printer with 1.75 mm diameter. 2 kg of wire are wound on the spool.
Retired
No product available!
No product available!
No product available!
No product available!
The Finder 66.82.8.230.0000 is a high current DPDT relay, operating on a coil voltage of 230V AC, capable of switching currents up to 30A at 250VAC on each of its two contacts. Its durable construction makes it ideal for industrial applications, while its strong leads and optional adapters facilitate installation and integration into a variety of systems.
Retired
No product available!
VisionCB-RT-STD is a base plate for VisionSOM-RT modules (i.MX RT). The tile contains, among others Ethernet, USB connectors, connectors compatible with Arduino shields and Raspberry Pi hat, 5 buttons and 5 LEDs. VisionCB-RT-STD, SoMLabs
Retired
No product available!
Assembled miniature reminder. AVT5638 C