.png)
- Out-of-Stock
DM183022
ID: 57254
Microchip PICDEM HPC Explorer Board
PICDEM HPC Explorer Board
This low-cost demo board is the ideal complement to the MPLAB® ICD 2 In Circuit Debugger to evaluate the performance of Microchip high-end 8-bit microcontrollers of the PIC18F series.
The board features a PIC18F8722 microcontroller, which is the superset of the entire 64- and 80-pin PIC18FXXXX general purpose 5V MCU family. Also, the HPC Explorer Board can easily be used to evaluate the PIC18 J-series 3V devices. The J-series products have Plug-in Modules that will automatically configure the voltage of the HPC Explorer Board to be 3V.
A daughter board (mezzanine) is also part of the kit and allows different processors sharing the same pin out to be mounted and tested on the Explorer board.
The same connector allows MPLAB ICE 4000 (and via an extension MPLAB ICE 2000) real-time in-circuit emulators to be attached to the board.
This low-cost demo board is the ideal complement to the MPLAB® ICD 2 In Circuit Debugger to evaluate the performance of Microchip high-end 8-bit microcontrollers of the PIC18F series.
The board features a PIC18F8722 microcontroller, which is the superset of the entire 64- and 80-pin PIC18FXXXX general purpose 5V MCU family. Also, the HPC Explorer Board can easily be used to evaluate the PIC18 J-series 3V devices. The J-series products have Plug-in Modules that will automatically configure the voltage of the HPC Explorer Board to be 3V.
A daughter board (mezzanine) is also part of the kit and allows different processors sharing the same pin out to be mounted and tested on the Explorer board.
The same connector allows MPLAB ICE 4000 (and via an extension MPLAB ICE 2000) real-time in-circuit emulators to be attached to the board.
Key Features:
- PIC18F8722, 128K Flash, 80-pin TQFP microcontroller
- Supports PIC18 J-series devices with Plug-in Modules (see part numbers below)
- Full pin break-out for easy wire wrap/prototyping
- Daughter board and MPLAB ICE2000/4000 connector (with switch to disable on board processor)
- 10 MHz crystal oscillator (to be used with internal PLL to provide 40 MHz operation)
- Convenient connection for MPLAB ICD 2 (In-Circuit Debugger) for in-circuit programming and debugging
- Power supply connector and programmable voltage regulator, capable of operation from 2.0 to 5.5V (requires any standard 9-12V power supply, also available separately)
- Potentiometer (connected to 10-bit A/D, analog input channel)
- Temperature sensor demo included (illustrates Microchip’s award winning TC74 device)
- 8 LEDs (connected to PORTD with jumper disable)
- RS-232 port (9 pin D type connector, UART1)
- Reset button
- Bootloader button
- PICtail ™ daughter board connector, to allow connection to standard expansion boards
- Serial bootloader ready (see AN851)
- 32 kHz crystal for Real Time Clock demonstration
Package Contents:
- PICDEM HPC Explorer Board
57254
Other products in the same category (16)
Infrared sensor that allows measurement of distances up to 15cm, has a built-in infrared illuminator, IR receiver and a perimeter of the received signal
Retired
No product available!
Miniature (22x13.5x6mm) WiFi module b / g / n with TCP and UDP protocols operating in standalone and access point modes. 2.0mm goldpin connector. The module is equipped with a UART interface, it is also possible to control GPIO lines (also as PWM). Powered by 3.3V. Antenna: copper wire
Retired
No product available!
Ultra miniature WiFi b/g/n module, equipped with UART, SPI, PWM and GPIO interfaces. The ability to work as an access point and in standalone mode. 3.3V power supply.HF-LPT200-1
Retired
No product available!
This transducer is about 45mm in diameter and has 4Ω impedance and should be run at about 5W
Retired
No product available!
SPIRIT1 868 MHz low power RF module with integrated microcontroller
Delivery date unknown
No product available!
Read/Write analog front end for 125 kHz RFID Basestation, SOIC16, EM Microrlectronic, RoHS
Retired
No product available!
Bitscope Micro is a miniature measuring instrument with a USB interface, it can act as an 8-channel logic analyzer (40MS / s, 3.3V or 5V) or a 2-channel oscilloscope (bandwidth up to 20MHz). In addition, Bitscope can generate a clock signal as well as sinusoidal, triangular, rectangular and saws
Retired
No product available!
High performance WLAN USB module which enables the Raspberry Pi to connect to a Wi-Fi network
Retired
No product available!
32-bit microcontroller from the STM32F4 family with ARM Cortex-M4 core, 256kB Flash, 128KB SRAM, I2C, HDMI-CEC, Irda, LIN, SPI, UART / USART, USB, DMA, PWM, 1.7 ... 3.6V, 64-LQFP
Retired
No product available!
32-bit microcontroller from the STM32F4 family with ARM Cortex-M4 core, 512kB Flash, 128KB SRAM, I2C, HDMI-CEC, Irda, LIN, SPI, UART / USART, USB, DMA, PWM, 1.7 ... 3.6V, 64-LQFP
Retired
No product available!
32-bit microcontroller from the STM32F4 family with ARM Cortex-M4 core, 512kB Flash, 128KB SRAM, I2C, HDMI-CEC, Irda, LIN, SPI, UART / USART, USB, DMA, PWM, 1.7 ... 3.6V, LQFP-144
Retired
No product available!
32-bit microcontroller from the STM32F4 family with ARM Cortex-M4 core, 512kB Flash, 128KB SRAM, I2C, HDMI-CEC, Irda, LIN, SPI, UART / USART, USB, DMA, PWM, 1.7 ... 3.6V, LQFP-100
Retired
No product available!
32-bit microcontroller from the STM32F4 family with ARM Cortex-M4 core, 256kB Flash, 128KB SRAM, I2C, HDMI-CEC, Irda, LIN, SPI, UART / USART, USB, DMA, PWM, 1.7 ... 3.6V, LQFP-100
Retired
No product available!
Kit for building a minisumo robot on a crawler chassis. It has a bulldozer, control board and a set of caterpillars. Robot version for self-assembly, requires additional motors and four AA batteries. Pololu 3124
Retired
No product available!
Expansion module kit with Arduino compatible connectors for building a Zumo robot. The module includes a dual engine controller, buzzer and user button, as well as a 3-axis accelerometer and compass. Pololu 2508
Retired
No product available!
Bi-directional converter enabling communication of any device equipped with an RS232 serial port with 802.11 b / g / n wireless WiFi network. The module can work as a TCP client / TCP or UDP server. The layout is "transparent" for communicating systems, which does not doubt facilitate communication between them.
Retired
No product available!
Microchip PICDEM HPC Explorer Board