CT-SE - development board with ATmega328P microcontroller

Description

CT-SE is an Arduino compatible board, based on the ATmega328P microcontroller from the AVR family. There are 14 I/O lines, 6 PWM channels, 6 analog inputs and communication interfaces (UART, SPI, I2C) at the user's disposal. The FT231X system realizes communication via the USB interface.

Compared to the original version of Arduino UNO Rev 3, the CT-UNO uses a micro USB connector, so the board can be powered, for example, from a Power Bank. In addition, an ATmega328P microcontroller in an SMD casing and a regulator of up to 1 A were used. The supply voltage range on the DC connector was also increased from 12 V to 15 V. The set was designed for learning programming and electronics.

Features

• ATmega328P microcontroller in SMD casing
• Flash memory: 32 KB
• SRAM memory: 2 KB
• EEPROM memory: 1 kB
• Clock speed: 16 MHz
• 14 digital I/O pins
• 6 PWM outputs
• 6 analog inputs
• UART, SPI, I2C interfaces
• 2 x external interrupts
• 6 pin ISP connector
• Compatible with Uno R3 Shield
• Indicator lights for power, TX, RX
• User LED D13
• FT231X chip realizing communication via USB
• Programmed in the Arduino IDE
• USB MicroB socket
• DC 7 to 15 V power connector
• Voltage regulator 500 mA 3.3 V
• Voltage regulator 1 A 5 V