- Out-of-Stock
The special construction of the braid facilitates installation in all conditions. Lanberg’s braid is built in such a way, so that one edge overlaps the other, forming a tube. The tuck (overlap) is about 25% of the tube's diameter. Braid is applied by stretching the edges and inserting cables inside. This cable accessory perfectly insulates and suppresses vibrations which is a very important factor in the case of applications for electronic equipment. Resistant to gasoline, chemicals (oil, lubricants), cleaning agents, UV radiation.
Manufacturer IMPAKT SPÓŁKA AKCYJNA Stanisława Lema 16 62-050 Mosina Poland zgody@impakt.com.pl
Responsible person IMPAKT SPÓŁKA AKCYJNA Stanisława Lema 16 62-050 Mosina Poland formularz kontaktowy na stronie osoby odpowiedzialnej
AVT kit for self-assembly of the regulator for the rectifier. AVT3166 B
No product available!
32-bit microcontroller with ARM Cortex-M4 core, XMC4200 family, 256kB Flash, VQFN-48, Infineon
No product available!
No product available!
No product available!
No product available!
A wireless energy consumption monitor with built-in memory, thanks to the analysis of daily consumption, can help reduce the cost of electricity consumption
No product available!
Dragino LoRa Shield is an expansion board for Arduino (Uno, Leonardo, Mega, DUE) with a LoRa communication module (RFM98W system). Works at 433 MHz, maximum power up to 100 mW. In the set with the plate there is also an antenna. Seeed studio 113990194
No product available!
No product available!
A kit for building an autonomous crawler robot based on the NVIDIA Jetson Nano B01. Waveshare JETANK AI Kit A
No product available!
No product available!
No product available!
HK Turnigy nano-tech 2200mah 6S 25~50C Lipo Pack (11913)
No product available!
No product available!
2-5/8" plastic Yellow wheel Futaba servo hub
No product available!
No product available!
No product available!
The special construction of the braid facilitates installation in all conditions. z28418